enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Punch down tool - Wikipedia

   en.wikipedia.org/wiki/Punch_down_tool

   A punch down tool, punchdown tool, IDC tool, or a Krone tool (named after the Krone LSA-PLUS connector), is a small hand tool used by telecommunication and network technicians. It is used for inserting wire into insulation-displacement connectors on punch down blocks , patch panels , keystone modules , and surface mount boxes (also known as ...

3. Battery holder - Wikipedia

   en.wikipedia.org/wiki/Battery_holder

   Battery types such as the 9-volt have snap-on contacts. Battery holders for zinc-air batteries must not be completely air-tight since approximately 1 litre of air is required per ampere-hour of discharge per cell. The battery holder may include a valve integrated with the device power switch to allow air to be admitted when the device is ...

4. Punch-down block - Wikipedia

   en.wikipedia.org/wiki/Punch-down_block

   For example, pushing a screwdriver down the middle of the block is a bad practice as it forces the two blades of the terminal post apart, leading to bad contacts. It is also possible to punch down multiple wires on top of each other in a single post of a punch-down block, but this practice is discouraged because of reliability concerns.

5. Battery terminal - Wikipedia

   en.wikipedia.org/wiki/Battery_terminal

   General Motors, and other automobile manufacturers, have also begun using side-post battery terminals, which consist of two recessed female 3/8" threads (SAE 3/8-16) into which bolts or various battery terminal adapters are to be attached. These side posts are of the same size and do not prevent incorrect polarity connections.

6. Wire bonding - Wikipedia

   en.wikipedia.org/wiki/Wire_bonding

   Wedge bonding can use large diameter wires or wire ribbons for power electronics application. Ball bonding is limited to small diameter wires, suitable for interconnect application. In either type of wire bonding, the wire is attached at both ends using a combination of downward pressure, ultrasonic energy, and in some cases heat, to make a weld .

7. Clamp (tool) - Wikipedia

   en.wikipedia.org/wiki/Clamp_(tool)

   A clamp is a fastening device used to hold or secure objects tightly together to prevent movement or separation through the application of inward pressure. In the United Kingdom the term cramp is often used instead when the tool is for temporary use for positioning components during construction and woodworking ; thus a G cramp or a sash clamp ...