enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Battery terminal - Wikipedia

   en.wikipedia.org/wiki/Battery_terminal

   General Motors, and other automobile manufacturers, have also begun using side-post battery terminals, which consist of two recessed female 3/8" threads (SAE 3/8-16) into which bolts or various battery terminal adapters are to be attached. These side posts are of the same size and do not prevent incorrect polarity connections.

3. Battery holder - Wikipedia

   en.wikipedia.org/wiki/Battery_holder

   Battery types such as the 9-volt have snap-on contacts. Battery holders for zinc-air batteries must not be completely air-tight since approximately 1 litre of air is required per ampere-hour of discharge per cell. The battery holder may include a valve integrated with the device power switch to allow air to be admitted when the device is ...

4. Hold down (structural engineering) - Wikipedia

   en.wikipedia.org/wiki/Hold_down_(structural...

   A hold down resisting uplift from a timber shear wall. Holdown (holdown, hold-down, or hold down) or tie-down in structural engineering refers to the steel device or hardware that is installed at the end of a plywood shear wall. The hold downs provide uplift resistance against the overturning moment imposed on the wall due to "in-plane" lateral ...

5. Battery management system - Wikipedia

   en.wikipedia.org/wiki/Battery_management_system

   A battery management system (BMS) is any electronic system that manages a rechargeable battery (cell or battery pack) by facilitating the safe usage and a long life of the battery in practical scenarios while monitoring and estimating its various states (such as state of health and state of charge), [1] calculating secondary data, reporting that data, controlling its environment ...

6. Power system protection - Wikipedia

   en.wikipedia.org/wiki/Power_system_protection

   Power system protection is a branch of electrical power engineering that deals with the protection of electrical power systems from faults [citation needed] through the disconnection of faulted parts from the rest of the electrical network. The objective of a protection scheme is to keep the power system stable by isolating only the components ...

7. Cable barrier - Wikipedia

   en.wikipedia.org/wiki/Cable_barrier

   High-tension cable consists of three or four pre-stretched cables supported by weak posts. Currently, all high-tension systems are proprietary, that is, marketed under exclusive right of a specific manufacturer. During installation, the cables are placed on the posts, and then tightened to a specific tension according to temperature. The ...

8. DieHard (brand) - Wikipedia

   en.wikipedia.org/wiki/DieHard_(brand)

   The DieHard brand is also used on hand tools, power tools, battery chargers, booster cables, power inverters, alkaline batteries, tires, work boots, and the batteries for Craftsman power tools. Battery chargers were initially made by Associated Equipment under the "608" model prefix, and then later Schumacher Electric under the "200" model prefix.

9. High-voltage cable - Wikipedia

   en.wikipedia.org/wiki/High-voltage_cable

   High voltage is defined as any voltage over 1000 volts. [3] Those of 2 to 33 kV are usually called medium voltage cables, those over 50 kV high voltage cables.. Modern HV cables have a simple design consisting of a few parts: the conductor, the conductor shield, the insulation, the insulation shield, the metallic shield, and the jacket.