Search results
Results from the WOW.Com Content Network
A slamfire is a premature, unintended discharge of a firearm that occurs as a round is being loaded into the chamber, when the bolt "slams" forward (hence the name), as a result of the firing pin having not been retracted into the bolt, or from the firing pin being carried forward by the momentum of returning to battery. Similar to a hammer ...
The .325 Winchester Short Magnum is a Delta L problem cartridge, meaning it can present unexpected chambering and/or feeding problems. The Delta L problem article explains this problem in more detail. [6] The German 8×68mm S cartridge introduced in 1939 is probably the closest ballistic twin of the .325 Winchester Short Magnum. The .325 ...
A choke is designed to alter or shape the distribution of the shot as it leaves the firearm. For shooting most game birds and clay pigeons, a desirable pattern is one that is as large as possible while being dense enough to ensure multiple hits on the target, at a particular range. The choke should be tailored to the range and size of the targets.
The least popular sizes are the 10 gauge and the 16 gauge; while far less common than the other four gauges, they are still commercially available. [citation needed] [9] Shotguns and shells exceeding 10 gauge, such as the 8 gauge, 6 gauge, 4 gauge, and 2 gauge are historically important in the United Kingdom and elsewhere in mainland Europe ...
This allows for the cartridge to be longer than the standardized 2.260" SAAMI maximum overall length. These cartridges can be safely loaded to a length that has the ogive portion of the bullet just touching the rifle's lands. Many competitive shooters will make these cartridges 0.005" less than the truly maximum allowable overall length, for ...
Modified choke or cylinder bore was furnished at no extra charge on special order only. The M37 was chambered in the following gauges and shells respectively: 12, 16, 20, 28, and 410 using 2 + 3 ⁄ 4-inch, 2 + 7 ⁄ 8-inch, 3-inch shells. The M37 unit weight was between 5 + 3 ⁄ 4 and 6 lbs; the fluctuation was dependent on the chambered gauge.
The widespread availability of standard size Mauser 98 rifles and the fact that the .375 H&H Magnum cartridge and its necked down version the .300 H&H Magnum with approximately 72 mm (2.83 in) case length were too long to fit in standard sized Mauser 98 bolt-action rifles makes the shorter 8×68mm S, 6.5×68mm and .375 Hölderlin interesting ...
The forend is connected to dual action bars which cycle the bolt when pulled back towards the receiver. As it travels to the rear, the shell latch is pushed out of the way by a camming surface on the action bar allowing a cartridge to drop into the carrier while the remaining shells in the magazine tube are held by the cartridge retaining latch.