Ad
related to: regenerative radio receiver kits for sale ebay cheap- Digital Cameras
Everything from Point-and-Shoot to
DSLRs, Lenses and Accessories
- Home Security
Easy Solutions to Monitor Your Home
Via Mobile App or Web Browser
- Home Audio
Experience Your Music Like Never
Before with New Home Audio Gear
- Car Stereos
Swap out Your Factory Radio to Get
the Latest Features in Your Car
- Digital Cameras
Search results
Results from the WOW.Com Content Network
A regenerative receiver, by contrast, could often provide adequate reception with the use of only one tube. In the 1930s the regenerative receiver was replaced by the superheterodyne circuit in commercial receivers due to the superheterodyne's superior performance and the falling cost of tubes.
The Neutrodyne radio receiver, invented in 1922 by Louis Hazeltine, was a particular type of tuned radio frequency (TRF) receiver, in which the instability-causing inter-electrode capacitance of the triode RF tubes is cancelled out or "neutralized" [1] [2] to prevent parasitic oscillations which caused "squealing" or "howling" noises in the speakers of early radio sets.
By the early 1930s National had established a reputation with the amateur radio community based upon their line of regenerative receivers, including the SW-3 and SW-5. National HRO receiver, circa 1938 Logo of National Company, late 1940s. In 1935 National introduced their top-of-the-line HRO receiver. This radio included two RF stages and a ...
Kit 7.5 MHz ext No 48 kHz 0/1 USB Yes Yes Yes SoftRock Lite II [113] Kit 1.891 – 1.795 MHz, 3.57 – 3.474 MHz, 7.104 – 7.008 MHz, 10.173 – 10.077 MHz, 14.095 – 13.999 MHz (also purchasable in other tunings) ext No 96 kHz 0/1 USB Yes Yes Yes SoftRock RX Ensemble II LF [114] Kit or Pre-built 180 kHz – 3.0 MHz ext No
This page was last edited on 20 October 2005, at 01:17 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike License 4.0; additional terms may apply.
The WD-11 vacuum tube, a triode, was introduced by the Westinghouse Electric corporation in 1922 for their Aeriola RF model radio and found use in other contemporary regenerative receivers (used as a detector-amplifier) including the Regenoflex and Radiola series.
This 1920s TRF radio manufactured by Signal is constructed on a breadboard Tuning a TRF receiver, like this 5 tube Neutrodyne set from 1924 with two stages of RF amplification, was a complicated process. The three tuned circuits, controlled by the 3 large knobs, had to be tuned in unison to the new station.
Classical regenerative receiver using a single triode vacuum tube. The orientation of the "tickler" coil was carefully adjusted by the operator in order to vary the amount of positive feedback. The regenerative receiver also had its heyday at the time where adding an active element (vacuum tube) was considered costly. In order to increase the ...
Ad
related to: regenerative radio receiver kits for sale ebay cheap