Search results
Results from the WOW.Com Content Network
V.32 (11/88) is an ITU-T recommendation for a modem operating as full-duplex on a 4-wire circuit, or half-duplex on a two-wire circuit, allowing bidirectional data transfer at either 9.6 kbit/s or 4.8 kbit/s at a symbol rate of 2,400 baud instead of the 600 baud of the V.22 standards.
This communication is done via an Ethernet crossover cable as opposed to a PC to DCE (hub, switch, or bridge) communication which is done via an Ethernet straight cable. V.35 is a high-speed serial interface designed to support both higher data rates and connectivity between DTEs (data-terminal equipment) or DCEs (data-communication equipment ...
A satellite modem or satmodem is a modem used to ... The LNB is usually powered by the modem through the signal cable with 13 or 18 V ... RS-422, V.35, G ...
In a classic example of this setup, each dial-up modem would connect to a modem relay gateway. ... wideband modems used, e.g., V.35 ... cable to convert it into a ...
Fokker V.35, a German prototype World War I fighter aircraft; ITU-T V.35, a wideband modem standard; LG V35 ThinQ, a smartphone; Nissan Skyline V35, an automobile
In network topology, a cable modem is a network bridge that conforms to IEEE 802.1D for Ethernet networking (with some modifications). The cable modem bridges Ethernet frames between a customer LAN and the coax network. Technically, it is a modem because it must modulate data to transmit it over the cable network, and it must demodulate data ...
The new design dropped the onboard CPU. The modem connected to the card used a 15-pin D-shell connector—which exactly matched the PC's game connector. Both models were powered by the PC. The new modem was frequency agile, with a configuration utility that ran on the PC to set up US and DS frequencies.
A DOCSIS 3.0 cable modem A cable modem termination system (CMTS) A DOCSIS architecture includes two primary components: a cable modem located at the customer premises, and a cable modem termination system (CMTS) located at the CATV headend. [27] The customer PC and associated peripherals are termed customer-premises equipment (CPE). The CPE are ...