enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Wire drawing - Wikipedia

    en.wikipedia.org/wiki/Wire_drawing

    Wire drawing is a metalworking process used to reduce the cross-section of a wire by pulling the wire through one or more dies. There are many applications for wire drawing, including electrical wiring, cables, tension-loaded structural components, springs, paper clips, spokes for wheels, and stringed musical instruments.

  3. Drawing (manufacturing) - Wikipedia

    en.wikipedia.org/wiki/Drawing_(manufacturing)

    The cold drawing process for steel bars and wire is as follows: Tube lubrication: The surface of the bar or tube is coated with a drawing lubricant such as phosphate or oil to aid cold drawing. Push Pointing: Several inches of the lead ends of the bar or tube are reduced in size by swaging or extruding so that it can pass freely through the ...

  4. Pearlite - Wikipedia

    en.wikipedia.org/wiki/Pearlite

    It has been recently shown that cold wire drawing not only strengthens pearlite by refining the lamellae structure, but also simultaneously causes partial chemical decomposition of cementite, associated with an increased carbon content of the ferrite phase, deformation induced lattice defects in ferrite lamellae, [3] and even a structural ...

  5. Aluminium alloy inclusions - Wikipedia

    en.wikipedia.org/wiki/Aluminium_alloy_inclusions

    Here are examples of problems related to inclusions: Pinholes in light gauge foil; Flange cracks in beverage containers; Surface streaks in bright automotive trim and lithographic material; Breakage in wire drawing operation; Increased tool wear and tear; Increased porosity; Loss of pressure tightness of engine blocks; Poor machinability

  6. Extrusion - Wikipedia

    en.wikipedia.org/wiki/Extrusion

    Drawing is a similar process, using the tensile strength of the material to pull it through the die. It limits the amount of change that can be performed in one step, so it is limited to simpler shapes, and multiple stages are usually needed. Drawing is the main way to produce wire. Metal bars and tubes are also often drawn.

  7. Electrical fault - Wikipedia

    en.wikipedia.org/wiki/Electrical_fault

    The time domain reflectometer sends a pulse down the wire and then analyzes the returning reflected pulse to identify faults within the electrical wire. In historic submarine telegraph cables , sensitive galvanometers were used to measure fault currents; by testing at both ends of a faulted cable, the fault location could be isolated to within ...

  8. Continuous casting - Wikipedia

    en.wikipedia.org/wiki/Continuous_casting

    Continuous casting, also called strand casting, is the process whereby molten metal is solidified into a "semifinished" billet, bloom, or slab for subsequent rolling in the finishing mills. Prior to the introduction of continuous casting in the 1950s, steel was poured into stationary molds to form ingots .

  9. Engineering drawing - Wikipedia

    en.wikipedia.org/wiki/Engineering_drawing

    Early examples of what would lead to more formal technical drawing practices included the drawings and geometric calculations used to construct aqueducts, bridges, and fortresses. Technical drawings also figured in the 12th-century design of cathedrals and castles, albeit such drawings were more typically produced by artisans and stonemasons ...