Search results
Results from the WOW.Com Content Network
Very close to wargaming 20 mm figure scale (20 mm is actually 1:80.5). [10] 1:76.2: 4 mm: Model railways (00) UK model rail scale 4 mm scale (OO Scale, etc.). 1:76: 4.011 mm: Model railways (00) Military models. Military vehicles. Used with 4 mm to 1 foot models as well. 1:75: 4.064 mm Used by Heller for model ships. Also some Japanese aircraft ...
1:32 scale is a traditional scale for models and miniatures, in which one unit (such as an inch or a centimeter) on the model represents 32 units on the actual object. It is also known as "three-eighths scale", since 3 ⁄ 8 inch represents a foot. A 6 ft (183 cm) tall person is modeled as 2 + 1 ⁄ 4 in (57 mm) tall in 1:32 scale.
For Morse taper-shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to 3¼ inches, and a single 1/4 inch increment to 3½ inches. One aspect of this method of sizing is that the size increment between drill bits ...
The major minus pitch also works for inch-based threads, but you must first determine the pitch by looking at the number of treads per inch (TPI; for example, 1 ⁄ 20 = 0.050 and 1 ⁄ 13 ≈ 0.077), and your result will only land near a tap drill size (not directly on one).
In music, a thirty-second note (American) or demisemiquaver (British) is a note played for 1 ⁄ 32 of the duration of a whole note (or semibreve).It lasts half as long as a sixteenth note (or semiquaver) and twice as long as a sixty-fourth (or hemidemisemiquaver).
A "dash 3 dash 4" (XXXXXX-3-4) designation indicates a 3 ⁄ 32-inch diameter and 4 ⁄ 16-inch (or 1 ⁄ 4-inch) length. Some rivets lengths are also available in half sizes, and have a dash number such as –3.5 (7 ⁄ 32 inch) to indicate they are half-size. The letters and digits in a rivet's identification number that precede its dash ...
This is approximately 1 / 8 inch per mile; 12.7 kilometres is exactly 500,000 standard inches and exactly 499,999 survey inches. This difference is substantial when doing calculations in State Plane Coordinate Systems with coordinate values in the hundreds of thousands or millions of feet.
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.