Search results
Results from the WOW.Com Content Network
Another common problem with the 2001–2006 5.3L engines was cracking cylinder heads. This is commonly called the "Castech Head" failure. GM issued a Technical Service Bulletin on this failure to help service technicians identify the problem. The head casting number (which can be viewed from the passenger side of the vehicle just in front of ...
Chevrolet went so far as to carry the positive crankcase ventilation system (PCV) over to the cross-ram induction system to retain emissions compliance mandated for U.S.-produced cars beginning in 1967, that also provided full-throttle crankcase pressure venting to the intake air to burn its vapors.
Vortec is a trademarked name for a line of gasoline engines for General Motors trucks. The name first appeared in an advertisement for the 1985 model year 4.3 L V6 that used "vortex technology" to create a vortex inside the combustion chamber , creating a better air / fuel atomization. [ 1 ]
The LB1 used in trucks and vans was referred to as Vortec in Chevrolet literature (named after a combustion chamber design known as a swirl port which twists the fuel mix from the intake ports as introduced with the Cavalier's 2.0L engine), and this name continued to be used with all truck and van 4.3 L (262 cu in) V6s until 2014.
$5.50 off each 24-pack of 16.9-ounce bottles. If you're tackling Dry January, San Pellegrino sparkling mineral water is a great way to mix things up.The 24-pack of 16.9-ounce bottles is $5.50 off ...
The LLV (also called Vortec 2900) is a 2.9 L; 178.3 cu in (2,921 cc) straight-4 DOHC engine produced between 2007 and 2012, with a 95.5 mm × 102 mm (3.76 in × 4.02 in) bore and a stroke. It replaced the LK5 and produced 185 hp (138 kW) at 5,600 rpm and 190 lb⋅ft (258 N⋅m) of torque at 2,800 rpm.
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
The engine block had 4.84-inch (123 mm) bore centers, two-bolt main bearing caps, a "side oiling" lubrication system (the main oil gallery located low on the driver's side of the crankcase), with full-flow oil filter, and interchangeable cylinder heads. Heads used on the high performance 409 and 427 engines had larger ports and valves than ...