enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. High-performance plastics - Wikipedia

   en.wikipedia.org/wiki/High-performance_plastics

   There are many synonyms for the term high-performance plastics, such as: high temperature plastics, high-performance polymers, high performance thermoplastics or high-tech plastics. The name high temperature plastics is in use due to their continuous service temperature (CST), which is always higher than 150 °C by definition (although this is ...

3. Tygon tubing - Wikipedia

   en.wikipedia.org/wiki/Tygon_Tubing

   Tygon R-3603 Laboratory Tubing is commonly used in chemical laboratories. It is often used in incubators and as a replacement for rubber tubing for Bunsen burners. This material is produced in vacuum sizes and can withstand a full vacuum at room temperature. It is a thermoplastic PVC-based material with plasticizer. [3]

4. Nylon 11 - Wikipedia

   en.wikipedia.org/wiki/Nylon_11

   As seen in the table below, Nylon 11 has lower values of density, flexural and Young's modulus, water absorption, as well as melting and glass transition temperatures. Nylon 11 is seen to have increased dimensional stability in the presence of moisture due to its low concentration of amides. Nylon 11 experiences 0.2-0.5% length variation and 1. ...

5. Heat-shrink tubing - Wikipedia

   en.wikipedia.org/wiki/Heat-shrink_tubing

   From near microscopically-thin-wall tubing to rigid, heavy-wall tubing, each type has precise design and chemical additives that make it suitable for meeting any of a wide variety of environmental demands. Heat-shrink tubing is rated by its expansion ratio, a comparison of the differences in expansion and recovery rate.

6. Plastic extrusion - Wikipedia

   en.wikipedia.org/wiki/Plastic_extrusion

   Plastics extrusion is a high-volume manufacturing process in which raw plastic is melted and formed into a continuous profile. Extrusion produces items such as pipe/tubing, weatherstripping , fencing, deck railings , window frames , plastic films and sheeting, thermoplastic coatings, and wire insulation.

7. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   An elbow is installed between two lengths of pipe (or tubing) to allow a change of direction, usually a 90° or 45° angle; 22.5° elbows are also available. The ends may be machined for butt welding, threaded (usually female), or socketed. When the ends differ in size, it is known as a reducing (or reducer) elbow.