Search results
Results from the WOW.Com Content Network
1×6 pin header (one row) 1×6 female header (one row) A pin header (or simply, header) is a form of electrical connector. A male pin header consists of one or more rows of metal pins molded into a plastic base, often 2.54 mm (0.1 in) apart, though available in many spacings. [1] Male pin headers are cost-effective due to their simplicity.
BTB connectors are divided up into four mounting types: Through-hole technology; Surface-mount technology; Plug-in technology [1]; Solderless stacking mezzanine technology [2]; BTB connectors are selected by considering the mounting method, pin pitch, number of the rows (aka number of the ways), pin length, stacker height etc.
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.
The interface dimensions for SMA connectors are listed in MIL-STD-348. [5] The SMA connector employs a 1 ⁄ 4 inch diameter, 36-thread-per-inch threaded barrel. The male is equipped with a hex nut measuring 5 ⁄ 16 inch (0.3125 inch / 7.9 mm) across opposite flats, thus taking the same wrench as a #6 SAE hex nut.
The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.
Pins and sockets can be arranged in any combination in a single housing, and each housing can be either male or female. There are three typical pin sizes: 1.57 mm (0.062 in), 2.13 mm (0.084 in), and 2.36 mm (0.093 in). The 1.57 mm pin can carry 5 A of current, while the 2.36 mm can carry 8.5 A.
[6]: 56 (e.g. pin headers, screw terminals, board-to-board connectors) Splice or butt connectors (primarily insulation displacement connectors ) that permanently join two lengths of wire or cable In computing, electrical connectors are considered a physical interface and constitute part of the physical layer in the OSI model of networking.
2.1 mm center pin Common on guitar effect pedals Arduino power adapter IEC 60130-10 Type A (first of two with same type and same OD, the other has ID of 2.5mm and center PIN) 5.50 2.10 CUI Inc. P10 Kobiconn 7391 Philmore 2560 Switchcraft 768K [8] 2.1 mm center pin, lock-ring: 5.50 2.10 Kobiconn 0721-EX Kobiconn 1000-EX (panel) 2.1 mm center pin ...