enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. RML 2.5-inch mountain gun - Wikipedia

   en.wikipedia.org/wiki/RML_2.5-inch_Mountain_Gun

   Writers who refer to "7-pounders" in World War I are in fact referring to this 2.5-inch (64 mm) gun. Romania bought 36 of these guns in 1883–1884, being designated in the local military nomenclature as "63 mm Armstrong mountain guns model 1883". They were the first guns designed for mountain warfare in Romanian use.

3. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   Flat-blade jeweler's screwdrivers and the tips found in 1 ⁄ 4-inch or 6.4-millimeter drive sets are generally hollow-ground. Note that it is this typical chisel shape which allows 9 screwdriver sizes to drive 24 different slotted screw sizes, with the drawbacks of not fitting as closely as a hollow-ground screwdriver would, and increasing the ...

4. Punched tape - Wikipedia

   en.wikipedia.org/wiki/Punched_tape

   Tape for punching was usually 0.00394 inches (0.100 mm) thick. The two most common widths were 11 ⁄ 16 inch (17 mm) for five bit codes, and 1 inch (25 mm) for tapes with six or more bits. Hole spacing was 0.1 inches (2.5 mm) in both directions. Data holes were 0.072 inches (1.8 mm) in diameter; sprocket feed holes were 0.046 inches (1.2 mm). [8]

5. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.

6. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   The correct tool to start a traditionally drilled hole (a hole drilled by a high-speed steel (HSS) twist drill bit) is a spotting drill bit (or a spot drill bit, as they are referenced in the U.S.). The included angle of the spotting drill bit should be the same as, or greater than, the conventional drill bit so that the drill bit will then ...

7. Washer (hardware) - Wikipedia

   en.wikipedia.org/wiki/Washer_(hardware)

   They could be used for sealing small holes, rust spots or removed pipe connections in water tanks or large cooking vessels. Spherical washer nut and screw Part of a self-aligning nut ; it is a washer with one radiused surface, which is designed to be used in conjunction with a mating nut in order to allow for up to several degrees of ...