Search results
Results from the WOW.Com Content Network
Carbonate hardness, is a measure of the water hardness caused by the presence of carbonate (CO 2− 3) and bicarbonate (HCO − 3) anions. Carbonate hardness is usually expressed either in degrees KH (from the German "Karbonathärte"), or in parts per million calcium carbonate ( ppm CaCO 3 or grams CaCO 3 per litre|mg/L).
Mohs hardness of materials (data page) Vickers hardness test; Brinell scale This page was last edited on ...
Total alkalinity is not (much) affected by temperature, pressure, or pH, and is thus itself a conservative measurement, which increases its usefulness in aquatic systems. All anions except HCO − 3 and CO 2− 3 have low concentrations in Earth's surface water (streams, rivers, and lakes). Thus carbonate alkalinity, which is equal to [HCO − ...
A bathtub faucet with built-up calcification from hard water in Southern Arizona. Hard water is water that has a high mineral content (in contrast with "soft water"). Hard water is formed when water percolates through deposits of limestone, chalk or gypsum, [1] which are largely made up of calcium and magnesium carbonates, bicarbonates and sulfates.
The grain per gallon (gpg) is a unit of water hardness defined as 1 grain (64.8 milligrams) of calcium carbonate dissolved in 1 US gallon of water (3.785412 L). It translates into 1 part in about 58,000 parts of water or 17.1 parts per million (ppm). Also called Clark degree (in terms of an imperial gallon).
Carbonate hardness is a measure of the concentration of carbonates such as calcium carbonate (CaCO 3) and magnesium carbonate (MgCO 3) per volume of water. As a unit 1 dKH is the same as 1 °dH which is equal to approximately 0.1786 mmol/L or 10.02 milligrams (mg) of calcium carbonate per litre of water, i.e. 17.86 ppm.
The relative amounts of each species in a body of water depends on physical variables including temperature and salinity, as well as chemical variables like pH and gas partial pressure. Variables like alkalinity and dissolved (or total) inorganic carbon further define a mass and charge balance that constrains the total state of the system. [1] [2]
The apexes of the anion plot are sulfate, chloride and carbonate plus hydrogen carbonate anions. The two ternary plots are then projected onto a diamond. [ 3 ] The diamond is a matrix transformation of a graph of the anions ( sulfate + chloride / total anions) and cations ( sodium + potassium /total cations).