Search results
Results from the WOW.Com Content Network
The same principle applies, and (for example) a current of 10 amps used for 12 hours each 24-hour day represents an average current of 5 amps, but an RMS current of 7.07 amps, in the long term. The term RMS power is sometimes erroneously used (e.g., in the audio industry) as a synonym for mean power or average power (it is proportional to the ...
The RMS value of an alternating current is also known as its heating value, as it is a voltage which is equivalent to the direct current value that would be required to get the same heating effect. For example, if 120 V AC RMS is applied to a resistive heating element it would heat up by exactly the same amount as if 120 V DC were applied.
On the other hand the RMS describes which direct current delivers the same amount of power within the same time period. The average of a symmetric alternating value is zero and it is therefore not useful to characterize it. Thus the easiest way to determine a quantitative measurement size is to use the average rectified value.
The neutral current can be determined by adding the three phase currents together as complex numbers and then converting from rectangular to polar co-ordinates. If the three-phase root mean square (RMS) currents are I L 1 {\displaystyle I_{L1}} , I L 2 {\displaystyle I_{L2}} , and I L 3 {\displaystyle I_{L3}} , the neutral RMS current is:
The peak-to-average power ratio (PAPR) is the peak amplitude squared (giving the peak power) divided by the RMS value squared (giving the average power). [1] It is the square of the crest factor. When expressed in decibels, crest factor and PAPR are equivalent, due to the way decibels are calculated for power ratios vs amplitude ratios.
In electronics and electrical engineering, the form factor of an alternating current waveform (signal) is the ratio of the RMS (root mean square) value to the average value (mathematical mean of absolute values of all points on the waveform). [1] It identifies the ratio of the direct current of equal power relative to the given alternating ...
The average age of participants was about fifty-nine years old. The researchers had data from blood samples, blood pressure, and BRI. They also had baseline data on lifestyle risk factors.
A sine wave, over one cycle (360°). The dashed line represents the root mean square (RMS) value at (about 0.707). Below an AC waveform (with no DC component) is assumed. The RMS voltage is the square root of the mean over one cycle of the square of the instantaneous voltage.