Ads
related to: high-pinion dana 70 (new gm version) 3 bolt rear end gear ratioebay.com has been visited by 1M+ users in the past month
walmart.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
The Dana 70 rear axle was first used in the Dodge W300 in 1958. The Dana 70 started out using 10 spline pinions and 23 spline axle shafts. The later, more current, Dana 70 axles use 29 spline pinions and 32 or 35 spline axle shafts. Dana offered two different limited slip differentials with the Dana 70, the "Powr-Lok" and the "Trac-Lok."
The 10.5" 14-bolt differential and axle is quite popular with Jeep Wrangler owners who want to upgrade their standard Dana 30, Dana 35, or Dana 44 axle. While the 10.5" 14-bolt axle is heavier than the standard Dana axles offered on the Wrangler, it is much stronger.
A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick 3300/3800 V6; Cadillac HT4100/4.5/4.9 L V8; Isuzu all 3.2 and 3.5L DOHC V6
The benefit is the larger ring gear, better angle cut on the teeth and Dana 60 diameter pinion shaft. The Dana Spicer Max momentary output torque FT-lbs Low pinion Dana 44 30 spline.....3460 [ft-lbs] High pinion Dana 44 30 spline.....4170 [ft-lbs] Low pinion rear 8.9" Dana 44 32 spline..5340 [ft-lbs]
Dana differential case #706400 [3] [4] (3.07-3.73) shows in Dana's parts catalog to be Dana 61-specific [citation needed]. The 706040x carrier can be purchased relatively inexpensively and used to install lower gears in a Dana 61 axle, such as when replacing a broken or damaged Dana 60 with a Dana 61 while retaining the factory gear ratio.
Dana 80's are made as full floating, rear axles only and are a step up in overall strength compared to the Dana 70. 1988 Ford was the first company to use the Dana 80. The Dana 80 has a GAWR up to 11,000 pounds (5,000 kg), however it is common practice among manufacturers to derate Dana 80's. Gross axle weight ratings are lowered by the vehicle ...
The functions of this design are to change the axis of rotation by 90 degrees (from the propshaft to the half-shafts) and provide a reduction in the gear ratio. The components of the ring-and-pinion differential shown in the schematic diagram on the right are: 1. Output shafts 2. Drive gear 3. Output gears 4. Planetary gears 5. Carrier 6.
The first version was produced from 1985 to 1992. The second version, produced from 1993 to 1997 featured a stronger pinion/yoke. This corrected a known, but rare, issue of the pinion yoke nut working loose. The first and second versions of the 10.25 axle are colloquially known as “short pinion-yoke” and “long pinion-yoke” respectively.
Ads
related to: high-pinion dana 70 (new gm version) 3 bolt rear end gear ratioebay.com has been visited by 1M+ users in the past month
walmart.com has been visited by 1M+ users in the past month