Ads
related to: 2.5 hard drive sata connector cable for computer desktop pc
Search results
Results from the WOW.Com Content Network
A data cable (top) and control cable (below) connecting a controller card and an ST-506 type HDD. Power cable not shown. The earliest hard disk drive (HDD) interfaces were bit serial data interfaces that connected an HDD to a controller with two cables, one for control and one for data.
A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...
Later, the micro-SATA interface made the total length 78.5mm. 1.8-inch drives with ZIF connectors were used in digital audio players, such as the iPod Classic, and subnotebooks. Later 1.8-inch drives were updated with a micro-SATA connector and up to 320GB of storage (Toshiba MK3233GSG).
Goals included being usable in existing 2.5" and 3.5" form factors, to be hot swappable and to allow legacy SAS and SATA drives to be mixed using the same connector family. [2] In June 2015, the SFFWG announced that the connector was being renamed to U.2. [3]
Inner view of a 1998 Seagate HDD that used the Parallel ATA interface 2.5-inch SATA drive on top of 3.5-inch SATA drive, showing close-up of (7-pin) data and (15-pin) power connectors. Current hard drives connect to a computer over one of several bus types, including parallel ATA, Serial ATA, SCSI, Serial Attached SCSI (SAS), and Fibre Channel.
Parallel ATA (PATA), originally AT Attachment, also known as Integrated Drive Electronics (IDE), is a standard interface designed for IBM PC-compatible computers.It was first developed by Western Digital and Compaq in 1986 for compatible hard drives and CD or DVD drives.
securing a 3.5-inch hard disk drive to the case; holding an expansion card in place by its metal slot cover; fastening case components to one another; usually, one or more #6-32 UNC screws hold the main cover on the case; They are almost always provided with a #2 Phillips drive. Sometimes a Green Robertson or Torx drive is used instead. All ...
The Serial ATA interface was designed primarily for interfacing with hard disk drives (HDDs), doubling its native speed with each major revision: maximum SATA transfer speeds went from 1.5 Gbit/s in SATA 1.0 (standardized in 2003), through 3 Gbit/s in SATA 2.0 (standardized in 2004), to 6 Gbit/s as provided by SATA 3.0 (standardized in 2009). [9]
Ads
related to: 2.5 hard drive sata connector cable for computer desktop pc