Ads
related to: high-pinion dana 70 (new gm version) 3 bolt rear end gear ratio calculator chartebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
All Dana 70 rear axles are full floating and typically have a gross axle rating of 7,500 lb (3,400 kg). The Dana 70 rear axle was first used in the Dodge W300 in 1958. The Dana 70 started out using 10 spline pinions and 23 spline axle shafts. The later, more current, Dana 70 axles use 29 spline pinions and 32 or 35 spline axle shafts.
The 10.5" 14-bolt differential and axle is quite popular with Jeep Wrangler owners who want to upgrade their standard Dana 30, Dana 35, or Dana 44 axle. While the 10.5" 14-bolt axle is heavier than the standard Dana axles offered on the Wrangler, it is much stronger.
A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick 3300/3800 V6; Cadillac HT4100/4.5/4.9 L V8; Isuzu all 3.2 and 3.5L DOHC V6
Dana differential case #706400 [3] [4] (3.07-3.73) shows in Dana's parts catalog to be Dana 61-specific [citation needed]. The 706040x carrier can be purchased relatively inexpensively and used to install lower gears in a Dana 61 axle, such as when replacing a broken or damaged Dana 60 with a Dana 61 while retaining the factory gear ratio.
Dana 80's are made as full floating, rear axles only and are a step up in overall strength compared to the Dana 70. 1988 Ford was the first company to use the Dana 80. The Dana 80 has a GAWR up to 11,000 pounds (5,000 kg), however it is common practice among manufacturers to derate Dana 80's. Gross axle weight ratings are lowered by the vehicle ...
The GM 9.25 IFS has been the main front differential in Four-wheel drive 3/4 Ton and 1 Ton GM trucks since 1988. The Dana 60 solid axle front end was used selectively in trucks with a higher GVWR from 1988 to 1991. The original Saginaw 9.5 differential, ring and pinion were modified to work with the independent front suspension.
For model year 2000 - 2004 trucks, the F-150 7700 offered this axle and the F-250 light duty was discontinued. At least till 2011 the 12 bolt semi float was still found with the heavy duty f-150. Gear ratios were 3.73 in 4x4 and either the 3.73 or 4.10 in the two-wheel-drive models. This was available in both limited slip and standard variations.
The benefit is the larger ring gear, better angle cut on the teeth and Dana 60 diameter pinion shaft. The Dana Spicer Max momentary output torque FT-lbs Low pinion Dana 44 30 spline.....3460 [ft-lbs] High pinion Dana 44 30 spline.....4170 [ft-lbs] Low pinion rear 8.9" Dana 44 32 spline..5340 [ft-lbs]
Ads
related to: high-pinion dana 70 (new gm version) 3 bolt rear end gear ratio calculator chartebay.com has been visited by 1M+ users in the past month