Search results
Results from the WOW.Com Content Network
A lightbulb socket, lightbulb holder, light socket, lamp socket or lamp holder is a device which mechanically supports and provides electrical connections for a compatible electric lamp base. [1] Sockets allow lamps to be safely and conveniently replaced (re-lamping).
The two most recent variants of the cap lamp are the GEN 4 and GEN 5 models. The GEN 4 model, approved for use by the Mine Safety and Health Administration (MHSA), uses the headpiece of existing cap lamps, but retrofitted with new LEDs and electronics. The GEN 5 model is very similar to the GEN 4 model except with a more intense spot beam that ...
The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...
1909 Cap (helmet) lamps introduced in Scotland 1911 Prize offered for best electrical lamp 1911 Coal Mines Act made requirements for pit managers to take examinations, where can be used (including electrical), etc. 1920 Electrical lamp with built in accumulator 1924 Miners Lamp Committee – tests and recommendations
The Sussmann lamp [58] was introduced into Britain in 1893 and following trials at Murton Colliery in Durham it became a widely used electric lamp with 3000 or so reported by the company in use in 1900 [59] However, by 1910 there were only 2055 electric lamps of all types in use – about 0.25% of all safety lamps. [60]
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Aftermarket Parts: These are replacement parts made by companies other than the original manufacturer. They can serve as cost-effective substitutes for OEM parts. Used or Second-Hand Parts: These can be either OEM or aftermarket parts that have been refurbished and resold at a lower price. [2]
The lamp-cap and counterweight move in opposite directions (both away from the base or both towards it). The balance that is required is shown by the following formula: d 1 = Lamp-cap to base; m 1 = weight of lamp-cap d 2 = counterweight to base; m 2 = weight of counterweight m 1 × d 1 = m 2 × d 2