Search results
Results from the WOW.Com Content Network
A grease gun (pneumatic) A grease gun is a common workshop and garage tool used for lubrication. The purpose of the grease gun is to apply lubricant through an aperture to a specific point, usually from a grease cartridge to a grease fitting or 'nipple'. The channels behind the grease nipple lead to where the lubrication is needed.
The M3 is an American .45-caliber submachine gun adopted by the U.S. Army on 12 December 1942, as the United States Submachine Gun, Cal. .45, M3. [13] The M3 was chambered for the same .45 ACP round fired by the Thompson submachine gun , but was cheaper to mass produce and lighter, at the expense of accuracy. [ 13 ]
The FIC Mk. 9 is a sub-machine gun designed by a private venture of Floro International Corporation (FIC) based in Tanay, Rizal Province in the Philippines.The weapon is marketed to local security forces as a low-cost alternative to imported submachine guns and is currently in limited use by the Philippines Marines and the Philippines Navy.
Drilling a blast hole with a pneumatic drill (jackhammer). A pneumatic tool, air tool, air-powered tool or pneumatic-powered tool is a type of power tool, driven by compressed air supplied by an air compressor. Pneumatic tools can also be driven by compressed carbon dioxide (CO 2) stored in small cylinders allowing for portability. [1]
Grease fitting on a bearing A grease nipple on the driver's door of a 1956 VW Beetle. A grease fitting, grease nipple, Zerk fitting, grease zerk, Alemite fitting, or divit is a metal fitting used in mechanical systems to feed lubricants, usually lubricating grease, into a bearing under moderate to high pressure using a grease gun.
Philippines: assault rifle: 5.56×45mm NATO: M16A1 >30,000 Current standard-issue rifle, either made by Colt USA or Elisco Tool (Elitool) Philippines. 30,000 units were handed-over to the PNP on loan from the Armed Forces of the Philippines, several are with the PNP-SAF. Norinco CQ China: assault rifle: 5.56×45mm NATO: CQ-A5b 6000 [67] [68]
UDMC PVAR rifles are Filipino variants of the Armalite AR-15 and AR-10, using the Pneumatic Valve and Rod system manufactured by United Defense Manufacturing Corporation.. The Pneumatic Valve and Rod system was created to be a more reliable alternative to the Stoner bolt and carrier piston system used in the AR-15 family, commonly but incorrectly referred to as a direct impingement system.
The low projectile speed requirement of a toy weapon greatly reduces the amount of air pressure needed; combined with the importance of safety in the toy industry, this has led to widespread adoption of pneumatic firing mechanisms in toy weapons, where a propellant reaction is not appropriate (although other technologies, such as rubber bands, can be used).