Search results
Results from the WOW.Com Content Network
The physical phenomena on which the device relies (such as spinning platters in a hard drive) will also impose limits; for instance, no spinning platter shipping in 2009 saturates SATA revision 2.0 (3 Gbit/s), so moving from this 3 Gbit/s interface to USB 3.0 at 4.8 Gbit/s for one spinning drive will result in no increase in realized transfer rate.
A SATA 2.0 (3 Gbit/s) PCI Express ×1 expansion card, having two built-in SATA port multipliers (square chips to the left and right of the middle of PCB) that "splice" card chipset's two SATA ports into a total of eight ports. A Serial ATA port multiplier (SATA PM) is a device that allows multiple SATA devices to be connected to a single SATA ...
A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...
The SAS is a new generation serial communication protocol for devices designed to allow for much higher speed data transfers and is compatible with SATA. SAS uses a mechanically identical data and power connector to standard 3.5-inch SATA1/SATA2 HDDs, and many server-oriented SAS RAID controllers are also capable of addressing SATA hard drives.
The data transfer rate of a drive (also called throughput) covers both the internal rate (moving data between the disk surface and the controller on the drive) and the external rate (moving data between the controller on the drive and the host system). The measurable data transfer rate will be the lower (slower) of the two rates.
Mechanically, connectors on the host side retain their backward compatibility in a way similar to how USB 3.0 does it – the new host-side SATA Express connector is made by "stacking" an additional connector on top of two legacy standard SATA data connectors, which are regular SATA 3.0 (6 Gbit/s) ports that can accept legacy SATA devices.
In this case, the maximum throughput is often called net bit rate or useful bit rate. To determine the actual data rate of a network or connection, the "goodput" measurement definition may be used. For example, in file transmission, the "goodput" corresponds to the file size (in bits) divided by the file transmission time.
In computer networking, a port or port number is a number assigned to uniquely identify a connection endpoint and to direct data to a specific service. At the software level, within an operating system, a port is a logical construct that identifies a specific process or a type of network service.