Search results
Results from the WOW.Com Content Network
The precise tensile strength of diamond is unknown, though strength up to 60 GPa has been observed, and theoretically it could be as high as 90–225 GPa depending on the sample volume/size, the perfection of diamond lattice and on its orientation: Tensile strength is the highest for the [100] crystal direction (normal to the cubic face ...
Finger nail is 2.5, copper coin is 3.5, glass is 5.5 and steel is 6.5. Hardness scale is Talc is 1, Gypsum is 2, Calcite is 3, Fluorite is 4, Apatite is 5, Orthoclase Feldspar is 6, Quartz is 7, Topaz is 8, Corundum is 9 and Diamond is 10. Odor; Not always recommended. Does the mineral have an odor of oil, sulfur or something else or is there ...
Today, diamonds are located in the diamond-rich density fraction with the help of X-ray fluorescence, after which the final sorting steps are done by hand. Before the use of X-rays became commonplace, [111] the separation was done with grease belts; diamonds have a stronger tendency to stick to grease than the other minerals in the ore. [36]
In vitro studies exploring the dispersion of diamond nanoparticles in cells have revealed that most diamond nanoparticles exhibit fluorescence and are uniformly distributed. [21] Fluorescent nanodiamond particles can be mass produced through irradiating diamond nanocrystallites with helium ions. [22]
(A poorly cut 1.0-carat (200 mg) diamond may have the same diameter and appear as large as a 0.85-carat (170 mg) diamond.) The depth percentage is the overall quickest indication of the quality of the cut of a round brilliant. "Ideal" round brilliant diamonds should not have a depth percentage greater than 62.5%.
Fluorescence anisotropy; FLIM – Fluorescence lifetime imaging; Fluorescence microscopy; FOSPM – Feature-oriented scanning probe microscopy; FRET – Fluorescence resonance energy transfer; FRS – Forward Recoil Spectrometry, a synonym of ERD; FTICR or FT-MS – Fourier-transform ion cyclotron resonance or Fourier-transform mass spectrometry
Molecules have various states referred to as energy levels. Fluorescence spectroscopy is primarily concerned with electronic and vibrational states. Generally, the species being examined has a ground electronic state (a low energy state) of interest, and an excited electronic state of higher energy. Within each of these electronic states there ...
Simplified atomic structure of the NV center. The nitrogen-vacancy center (N-V center or NV center) is one of numerous photoluminescent point defects in diamond.Its most explored and useful properties include its spin-dependent photoluminescence (which enables measurement of the electronic spin state using optically detected magnetic resonance), and its relatively long (millisecond) spin ...