enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Thwart - Wikipedia

   en.wikipedia.org/wiki/Thwart

   A double banked boat has two oarsmen seated on each thwart, each of whom operates their own oar on their own side of the boat. This is generally found in larger boats. A third arrangement is where two oars, one each side of the boat, are worked by one person. (Technically, in salt water, this is the only use of an oar that is termed "rowing".

3. Capsizing - Wikipedia

   en.wikipedia.org/wiki/Capsizing

   The boat is then righted, bailed out, and the sails reset, so that in the event of an uncontrolled capsize, the boat and its occupants are familiar with the procedure and may recover. Most small monohull sailboats can normally be righted by standing or pulling down on the centreboard , daggerboard (or bilgeboard in a scow ) to lift the mast ...

4. Chine (boating) - Wikipedia

   en.wikipedia.org/wiki/Chine_(boating)

   As the boat's speed increases, hydrodynamic pressure beneath the pad causes the hull to ride higher in the water, so that eventually the boat will be riding solely upon the pad area. At low speeds these hulls ride and handle similarly to a comparable V-hull; but at high speeds the padded hull can both out-accelerate and have a higher top speed ...

5. German submarine U-163 (1941) - Wikipedia

   en.wikipedia.org/wiki/German_submarine_U-163_(1941)

   U-163 had a displacement of 1,120 tonnes (1,100 long tons) when at the surface and 1,232 tonnes (1,213 long tons) while submerged. [2] The U-boat had a total length of 76.76 m (251 ft 10 in), a pressure hull length of 58.75 m (192 ft 9 in), a beam of 6.76 m (22 ft 2 in), a height of 9.60 m (31 ft 6 in), and a draught of 4.70 m (15 ft 5 in).

6. Outrigger boat - Wikipedia

   en.wikipedia.org/wiki/Outrigger_boat

   The paddling stroke is similar to that of most other racing canoe paddling strokes, involving primarily core and lat strength. Generally, each paddler paddles on the opposite side from the paddler in directly front (for example, in an OC6, paddlers in seats 1, 3, and 5 paddle on one side, while paddlers in seats 2 and 4 paddle on the other side).

7. Strake - Wikipedia

   en.wikipedia.org/wiki/Strake

   In clinker boats, the rubbing strake was applied to the outside of the sheer strake. Many current pleasure craft reflect this history in that they have a mechanically attached (and therefore replaceable) rub rail at the location formerly occupied by a rubbing strake, often doubling to cover the joint between a GRP hull and its innerliner.