Search results
Results from the WOW.Com Content Network
An overhead valve engine, abbreviated (OHV) and sometimes called a pushrod engine, is a piston engine whose valves are located in the cylinder head above the combustion chamber. This contrasts with flathead (or "sidevalve") engines , where the valves were located below the combustion chamber in the engine block .
This reduced inertia in OHC engines results in less valve float at higher engine speeds (RPM). [1] A downside is that the system used to drive the camshaft (usually a timing chain in modern engines) is more complex in an OHC engine, such as the 4-chain valvetrain of the Audi 3.2 or the 2 meter chain on Ford cammers. Another disadvantage of OHC ...
The Ford Pinto engine was the unofficial name for a four-cylinder internal combustion engine built by Ford Europe.In Ford sales literature, it was referred to as the EAO or OHC engine and because it was designed to the metric system, it was sometimes called the "metric engine".
The most common use of a rocker arm is to transfer the motion of a pushrod in an overhead valve (OHV) internal combustion engine to the corresponding intake/exhaust valve. In an OHV engine the camshaft at the bottom of the engine pushes the pushrod upwards. The top of the pushrod presses upwards on one side of the rocker arm located at the top ...
Pushrods are long, slender metal rods that are used in overhead valve engines to transfer motion from the camshaft (located in the engine block) to the valves (located in the cylinder head). The bottom end of a pushrod is fitted with a lifter, upon which the camshaft makes contact. The camshaft lobe moves the lifter upwards, which moves the ...
Though it was designed as a pushrod engine, it was advanced for the time. [1] The pushrod version of the Lancia boxer was only ever used in the Flavia, and its derivatives including the Lancia 2000. In 1976, a new overhead cam engine based on a similar layout was designed and brought into production in 2 and 2.5-litre displacements for the Gamma.
The Jeep Tornado engine was the first post-World War II U.S.-designed mass-produced overhead cam (OHC) automobile engine. [1] The 230.5 cu in (3.78 L) hemi-headed straight-six was introduced in mid-year 1962, and replaced the flathead "6-226" Willys Super Hurricane that was in use since 1954.
Considered advanced by Detroit engineering standards at the time, the Pontiac OHC 6 followed the Jeep Tornado I6 as the second post-World War II domestic-developed and mass-produced overhead cam automobile engine. [6] The Pontiac's single camshaft was supported by journals within the aluminum valve cover; no separate bearing shells were used.