Search results
Results from the WOW.Com Content Network
It is used in some household stoves [1] and in some industrial process vessels (tanks), such as shell and tube heat exchangers, chemical reactors, and static mixers. Baffles are an integral part of the shell and tube heat exchanger design. A baffle is designed to support tube bundles and direct the flow of fluids for maximum
It can be horizontal, vertical or round vessel. [5] A vacuum action is created to pull in the gas cut mud. When the liquid enters the tank it will flow and be distributed to a layer of internal baffle plates designed for the mud to flow in thin laminar film and is exposed to a vacuum that forces the gas to escape and break out of the mud. [5]
The typical spray-type deaerator is a horizontal vessel which has a preheating section and a deaeration section. The two sections are separated by a baffle. Low-pressure steam enters the vessel through a sparger in the bottom of the vessel. The boiler feedwater is sprayed into section where it is preheated by the rising steam from the sparger.
Thermal treatment is a highly effective strategy for the control of zebra mussels (McMahon et al. 1995). Thermal treatment may include retrofitting a closed loop system to recirculate the heated water to the sea chest or the addition of a second sea chest system, allowing engine cooling water to be discharged through the idle sea chest.
Mud Gas Separator capable of handling 1000-1500gpm Process Flow Diagram For Mud Gas Separator. Mud Gas Separator is commonly called a gas-buster or poor boy degasser. It captures and separates the large volumes of free gas within the drilling fluid. If there is a "kick" situation, this vessel separates the mud and the gas by allowing it to flow ...
Dissolved air flotation (DAF) is a water treatment process that clarifies wastewaters (or other waters) by the removal of suspended matter such as oil or solids. The removal is achieved by dissolving air in the water or wastewater under pressure and then releasing the air at atmospheric pressure in a flotation tank basin.
A very similar process known as dissolved air flotation is also used for waste water treatment. Froth flotation is commonly used in the processing of mineral ores. IGF units in the oil industry do not use air as the flotation medium due to the explosion risk. These IGF units use natural gas or nitrogen to create the bubbles.
The two fluids can then be piped out of the separator from their respective sides of the baffle. The produced water is then either injected back into the oil reservoir, disposed of, or treated. The bulk level (gas–liquid interface) and the oil water interface are determined using instrumentation fixed to the vessel.