Search results
Results from the WOW.Com Content Network
An approach to the design and development of reliable product to prevent failure, based on the knowledge of root cause failure mechanisms. The Physics of Failure (PoF) concept is based on the understanding of the relationships between requirements and the physical characteristics of the product and their variation in the manufacturing processes ...
Failure mode and effects analysis (FMEA; often written with "failure modes" in plural) is the process of reviewing as many components, assemblies, and subsystems as possible to identify potential failure modes in a system and their causes and effects. For each component, the failure modes and their resulting effects on the rest of the system ...
Mechanical movement is the predominant failure mechanism causing mechanical and electromechanical devices to wear out. For many devices, the wear-out failure point is measured by the number of cycles performed before the device fails, and can be discovered by cycle testing. In cycle testing, a device is cycled as rapidly as practical until it ...
A part failure mode is the way in which a component failed "functionally" on the component level. Often a part has only a few failure modes. For example, a relay may fail to open or close contacts on demand. The failure mechanism that caused this can be of many different kinds, and often multiple factors play a role at the same time.
The failure mode may then be charted on a criticality matrix using severity code as one axis and probability level code as the other. For quantitative assessment, modal criticality number is calculated for each failure mode of each item, and item criticality number is calculated for each item. The criticality numbers are computed using the ...
Inversion and eversion are movements that tilt the sole of the foot away from (eversion) or towards (inversion) the midline of the body. [35] Eversion is the movement of the sole of the foot away from the median plane. [36] Inversion is the movement of the sole towards the median plane. For example, inversion describes the motion when an ankle ...
Under the functional failure mode approach, the actual functional failure modes of the product are identified during a DFMEA. During the detailed FMEDA, each component failure mode is mapped to a functional failure mode. The functional failure modes are then categorized according to product failure mode in a particular application. [13]
The type of movement that can be produced at a synovial joint is determined by its structural type. Movement types are generally paired, with one being the opposite of the other. Body movements are always described in relation to the anatomical position of the body: upright stance, with upper limbs to the side of body and palms facing forward. [11]