Search results
Results from the WOW.Com Content Network
A unique intake manifold that used the 48 mm (1.9 in) twin-bore throttle body from the 5.7L TPI Corvette engine was used on the engine's top end. [9] The turbocharged 4.3 L (262 cu in) was last used in the GMC Typhoon in the 1993 model year. The engine produced 280 hp (209 kW) at 4400 rpm and 360 lb⋅ft (488 N⋅m) of torque at 3600 rpm.
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used.
To meet OBD-II compliance, the Vortec engines replaced throttle-body fuel injection with sequential fuel injection, redesigned engine camshaft and cylinder heads, along with longer-life engine coolant and spark plugs. [14] The naturally-aspirated 6.5 L engine was discontinued (the turbodiesel remained offered for all C/K trucks). [14]
The 267 was introduced in 1979 for the GM F-body (Camaro), G-body (Chevrolet Monte Carlo, El Camino), A-body (Malibu Classic, 1979–1981) and also used on GM B-body cars (Impala and Caprice models). The 4.4 L; 267.8 cu in (4,389 cc) engine had the 350's crankshaft stroke of 3.48 in (88.4 mm) and the smallest bore of any small-block, 3.5 in (88 ...
In fuel injected engines, the throttle body is the part of the air intake system that controls the amount of air flowing into the engine, in response to driver accelerator pedal input in the main. The throttle body is usually located between the air filter box and the intake manifold, and it is usually attached to, or near, the mass airflow sensor.
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
The "XX" is a placeholder for the last two digits of the specific assembly code for each model. The platform, which replaced the GMT900 series that had been in production from 2007 to 2013, was introduced in April 2013 for the 2014 model year on the trucks, followed by the December 2013 production on the 2015 large SUVs that debuted in February ...
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.