enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Coaxial cable - Wikipedia

   en.wikipedia.org/wiki/Coaxial_cable

   Coaxial cable, or coax (pronounced / ˈ k oʊ. æ k s /), is a type of electrical cable consisting of an inner conductor surrounded by a concentric conducting shield, with the two separated by a dielectric (insulating material); many coaxial cables also have a protective outer sheath or jacket.

3. SHV connector - Wikipedia

   en.wikipedia.org/wiki/SHV_connector

   The SHV (safe high voltage) connector is a type of RF connector used for terminating a coaxial cable.The connector uses a bayonet mount similar to those of the BNC and MHV connectors, but is easily distinguished due to its very thick and protruding insulator. [1]

4. F connector - Wikipedia

   en.wikipedia.org/wiki/F_connector

   The F connector (also F-type connector) is a coaxial RF connector commonly used for "over the air" terrestrial television, cable television and universally for satellite television and cable modems, usually with RG-6/U cable or with RG-59/U cable.

5. TV aerial plug - Wikipedia

   en.wikipedia.org/wiki/TV_aerial_plug

   Belling-Lee connectors Flex Type F connectors. A TV aerial plug is a connector used to connect coaxial cables with each other and with terrestrial VHF/UHF roof antennas, antenna signal amplifiers, CATV distribution equipment, TV sets and FM / DAB-radio receivers.

6. Cable television - Wikipedia

   en.wikipedia.org/wiki/Cable_television

   Coaxial cable brings the signal to the customer's building through a service drop, an overhead or underground cable. If the subscriber's building does not have a cable service drop, the cable company will install one. The standard cable used in the U.S. is RG-6, which has a 75 ohm impedance, and connects with a type F connector. The cable ...

7. EIA RF Connectors - Wikipedia

   en.wikipedia.org/wiki/EIA_RF_Connectors

   The flange design, inner and outer conductor dimensions are standardized, by EIA, in the RS-225, 50 Ω (ohm), and RS-259, 75 Ω, standards.They are commonly referred to by the inner diameter of the outer conductor in fractional inches.