Search results
Results from the WOW.Com Content Network
Different dialysis tubing or flat membranes are produced and characterized as differing molecular-weight cutoffs (MWCO) ranging from 1–1,000,000 kDa. The MWCO determination is the result of the number and average size of the pores created during the production of the dialysis membrane.
In ultrafiltration, the molecular weight cut-off or MWCO of a membrane refers to the lowest molecular weight of the solute (in daltons) for which 90% of the solute is retained by (prevented from passing through) the membrane, [1] or the molecular weight of the molecule (e.g. globular protein) that is 90% retained by the membrane.
The MWCO of a membrane is the result of the number and average size of the pores created during production of the dialysis membrane. The MWCO typically refers to the smallest average molecular mass of a standard molecule that will not effectively diffuse across the membrane during extended dialysis.
The pore sizes of technical membranes are specified differently depending on the manufacturer. One common distinction is by nominal pore size. It describes the maximum pore size distribution [9] and gives only vague information about the retention capacity of a membrane. The exclusion limit or "cut-off" of the membrane is usually specified in ...
Nanotechnology is being used in some of the most recent high-flux membranes to create a uniform pore size. The goal of high-flux membranes is to pass relatively large molecules such as beta-2-microglobulin (MW 11,600 daltons), but not to pass albumin (MW ~66,400 daltons). Every membrane has pores in a range of sizes. As pore size increases ...
Schematic of semipermeable membrane during hemodialysis, where blood is red, dialysing fluid is blue, and the membrane is yellow. Kidney dialysis (from Greek διάλυσις, dialysis, 'dissolution'; from διά, dia, 'through', and λύσις, lysis, 'loosening or splitting') is the process of removing excess water, solutes, and toxins from the blood in people whose kidneys can no longer ...
It is widely used to measure minimum, maximum (or first bubble point) and mean flow pore sizes, and pore size distribution of the through pores in membranes [1] nonwovens, paper, filtration and ultrafiltration media, hollow fibers, [2] ceramics, etc. In capillary flow porometry an inert gas is used to displace a liquid, which is in the pores ...
Semipermeable membrane is a type of synthetic or biologic, polymeric membrane that allows certain molecules or ions to pass through it by osmosis. The rate of passage depends on the pressure , concentration , and temperature of the molecules or solutes on either side, as well as the permeability of the membrane to each solute.