Search results
Results from the WOW.Com Content Network
A circulator pump for home use. A circulator pump or circulating pump is a specific type of pump used to circulate gases, liquids, or slurries in a closed circuit with small elevation changes. They are commonly found circulating water in a hydronic heating or cooling system.
Continuing the calculation from two paragraphs above, air cooling needs ten times of the surface area, therefore the fins, and air needs 2000 times the flow velocity and thus a recirculating air fan needs ten times the power of a recirculating water pump. Moving heat from the cylinder to a large surface area for air cooling can present problems ...
Water is introduced into the steam drum and is circulated around the boiler, leaving only as steam. What makes the forced circulation boiler different is its use of a secondary pump that circulates water through the boiler. The secondary pump takes the feed water going to the boiler and raises the pressure of the water going in.
Five (5) numbers (4 working + 1 standby) circulating water pumps of vertical wet pit type, mixed flow design and self water lubricated complete along with motors and associated accessories. Electro-hydraulically operated butterfly valve (with actuators), isolating butterfly valve and rubber expansion joints at discharge of each pump.
Reciprocating pump has wide application and to clear the basic idea it is necessary to know the basic parts. The basic parts along with its function; Water reservoir - it is not a part of reciprocating pump, however, it is the main source where from the reciprocating pump takes the water. It may be a source of other fluid as well.
The compression ratio of the micropump as one of the critical performance indicator is defined as the ratio between the stroke volume, i.e. fluid volume displaced by the pump membrane over the course of the pump cycle, and the dead volume, i.e. the minimum fluid volume remaining in the pump chamber in pumping mode.
Single-stage vacuum pumps typically produce vacuum to 35 torr (mm Hg) or 47 millibars (4.7 kPa), and two-stage pumps can produce vacuum to 25 torr, assuming air is being pumped and the ring-liquid is water at 15 °C (59 °F) or less. Dry air and 15 °C sealant-water temperature is the standard performance basis, which most manufacturers use for ...
The liquid is not in contact with any mechanical elements. Therefore, neither the pump can be abraded (which is important for sandwater wells), nor the contents in the pipe (which is important for archeological research in the sea). Act as a water aerator and can in some configurations lift stagnant bottom water to the surface (of water tanks).