Search results
Results from the WOW.Com Content Network
To convert from / to / ... Carbon dioxide: 3.640 0.04267 Carbon disulfide: 11.77 ... 1 J·m 3 /mol 2 = 1 m 6 ·Pa/mol 2 = 10 L 2 ·bar/mol 2.
Some express the concentrations as ppmv (parts per million by volume) and some express the concentrations as mg/m 3 (milligrams per cubic meter), while others require adjusting or correcting the concentrations to reference conditions of moisture content, oxygen content or carbon dioxide content.
As another example, a regulation might limit the concentration of particulate matter to 0.1 grain per standard cubic foot (i.e., scf) of dry exhaust gas corrected to 12 volume percent CO 2. Environmental agencies in the USA often denote a standard cubic foot of dry gas as "dscf" or as "scfd".
Liquid carbon dioxide is the liquid state of carbon dioxide (CO 2 ), which cannot occur under atmospheric pressure. It can only exist at a pressure above 5.1 atm (5.2 bar; 75 psi), under 31.1 °C (88.0 °F) (temperature of critical point ) and above −56.6 °C (−69.9 °F) (temperature of triple point ). [ 1 ]
The contribution of the muscle to the specific heat of the body is approximately 47%, and the contribution of the fat and skin is approximately 24%. The specific heat of tissues range from ~0.7 kJ · kg−1 · °C−1 for tooth (enamel) to 4.2 kJ · kg−1 · °C−1 for eye (sclera). [13]
Change in volume with increasing ethanol fraction. The molar volume of a substance i is defined as its molar mass divided by its density ρ i 0: , = For an ideal mixture containing N components, the molar volume of the mixture is the weighted sum of the molar volumes of its individual components.
To convert heat values to joules per mole values, multiply by 44.095 g/mol. To convert densities to moles per liter, multiply by 22.678 cm 3 mol/(L·g). Data obtained from CRC Handbook of Chemistry and Physics , 44th ed. pages 2560–2561, except for critical temperature line (31.1 °C) and temperatures −30 °C and below, which are taken from ...
The conversion procedure for some units (for example, the Mach unit of speed) are built into Module:Convert as they are too complex to be specified in a table. That is indicated by entering a code (which must be the same as used in the module) in the Extra column.