Search results
Results from the WOW.Com Content Network
Relative bearing refers to the angle between the craft's forward direction and the location of another object. For example, an object relative bearing of 0 degrees would be immediately in front; an object relative bearing 180 degrees would be behind. [2] Bearings can be measured in mils, points, or degrees.
Internal stress to a bearing through application of negative clearance is known as bearing preloading. Advantages of preloading include the following: maintain axial and radial position for accurate displacements of angular movements; increase bearing rigidity; prevent sliding or gyroscope-like movements, especially with high acceleration or ...
In 1982 the U.S. Department of Justice Merger Guidelines introduced the SSNIP test as a new method for defining markets and for measuring market power directly. In the EU it was used for the first time in the Nestlé/Perrier case in 1992 and has been officially recognized by the European Commission in its "Commission's Notice for the Definition of the Relevant Market" in 1997.
The magnetic bearing to the station in this case is 350°. The ADF indicators are a kind of navigational display consisting of a dial and a needle that rotates around the dial and points to the beacon. This needle suggests the "to" bearing of the beacon, and to fly the "from" bearing, 180° needs to be added or subtracted from the reading. [7]
The formula to determine the compass heading to an NDB station (in a no wind situation) is to take the relative bearing between the aircraft and the station, and add the magnetic heading of the aircraft; if the total is greater than 360 degrees, then 360 must be subtracted. This gives the magnetic bearing that must be flown: (RB + MH) mod 360 = MB.
The RCSC specification has been adopted, in its entirety, by the American Institute of Steel Construction and appears as section 16 of that organization's Steel Construction Manual. DTIs within the RCSC specification section 8.2.4 are described thus: "ASTM F959 direct tension indicators are recognized in this Specification as a bolt-tension ...
[1] [2] In the case of two windings wound around the same core in parallel, for example, the polarity will be the same on the same ends: A sudden (instantaneous) current in the first coil will induce a voltage opposing the sudden increase in the first and also in the second coil, because the magnetic field produced by the current in the first ...
The Rockwell hardness test is a hardness test based on indentation hardness of a material. The Rockwell test measures the depth of penetration of an indenter under a large load (major load) compared to the penetration made by a preload (minor load). [1] There are different scales, denoted by a single letter, that use different loads or indenters.