Search results
Results from the WOW.Com Content Network
The LCL can be either computed or determined graphically using standard thermodynamic diagrams such as the skew-T log-P diagram or the tephigram.Nearly all of these formulations make use of the relationship between the LCL and the dew point, which is the temperature to which an air parcel needs to be cooled isobarically until its RH just reaches 100%.
Solutions for energy-efficient buildings that avoid condensation are a current topic of architecture. For climate control in buildings using HVAC systems, the key is to maintain the relative humidity at a comfortable range—low enough to be comfortable but high enough to avoid problems associated with very dry air.
For a constant temperature, the smaller the difference, the more moisture there is, and the higher the relative humidity. In the lower troposphere, more moisture (small dew point depression) results in lower cloud bases and lifted condensation levels (LCL). LCL height is an important factor modulating severe thunderstorms.
The main feature of thermodynamic diagrams is the equivalence between the area in the diagram and energy. When air changes pressure and temperature during a process and prescribes a closed curve within the diagram the area enclosed by this curve is proportional to the energy which has been gained or released by the air.
The convective condensation level (CCL) represents the height (or pressure) where an air parcel becomes saturated when heated from below and lifted adiabatically due to buoyancy. In the atmosphere, assuming a constant water vapor mixing ratio, the dew point temperature (the temperature where the relative humidity is 100%) decreases with ...
Condensation is the change of the state of matter from the gas phase into the liquid phase, and is the reverse of vaporization. The word most often refers to the water cycle . [ 1 ] It can also be defined as the change in the state of water vapor to liquid water when in contact with a liquid or solid surface or cloud condensation nuclei within ...
A high proportion of damp problems in buildings are caused by ambient climate dependent factors of condensation and rain penetration. [1] Capillary penetration of fluid from the ground up through concrete or masonry is known as "rising damp" and is governed by the shape and porosity of the construction materials through which this evaporation ...
Sintering is a direct application of capillary condensation, because of the adhesion effects of dust and powders. This application can be seen directly in sol-gel thin film synthesis. [7] The sol-gel is a colloid solution which is placed on a substrate, usually through a dip-coating method. After being placed onto the substrate, a source of ...