Search results
Results from the WOW.Com Content Network
The rather uncommon [citation needed] 40 mm figure scale wargames figures fit approximately into this scale. 1:45: 6.773 mm This is the scale which MOROP has defined for O scale, because it is half the size of the 1:22.5 Scale G-gauge model railways made by German manufacturers. [citation needed] 1:43.5: 7.02 mm: Model railways (0)
≈1:52 – 1:48: Heroic scale of 32 mm miniatures. 1:50 scale is a popular size for diecast models from European manufacturers. 1:48 is commonly known as quarter scale or American O scale. 40 mm: ≈7 mm: ≈1:45 – 1:43: Older figures from the 60s and tend to be thinner / shorter than new metal ones. Close to O scale model railroads. 54 mm ...
The 37.5 mm length is not derived by a certain scale ratio. While HO scale is a 1:87 scale (3.5 mm to 1 foot), resulting in a 16.5 mm (0.65 in) gauge from real life prototype 1,435 mm (4 ft 8 + 1 ⁄ 2 in) standard gauge standard gauge. Conversely, modeling standard gauge in Lego trains would yield a scaling of (37.5:1435 =) 1:38.3.
Alternatively 1.1/8 inch per foot is adopted, only Australia for ease of conversion. allowing a scale of 3/32 inch per full size inch. This results in an oversize locomotive and often negates building inside valve gear locomotives (such as the GWR King Class 4-6-0) due to frame width restrictions caused by 5 in ( 127 mm ) gauge track.
N scale is a popular model railway scale. [1] Depending upon the manufacturer (or country), the scale ranges from 1:148 to 1:160. Effectively the scale is 1:159, 9 mm to 1,435 mm (4 ft 8 + 1 ⁄ 2 in), which is the width of standard gauge railway. However the scale may vary to simulate wide or narrow-gauge rail.
The term "second" comes from "the second minute division of an hour", as it is 1 ⁄ 60 of a minute, or 1 ⁄ 60 of 1 ⁄ 60 of an hour. While usually sub-second units are represented with SI prefixes on the second (e.g. milliseconds ), this system can be extrapolated further, such that a "Third" would mean 1 ⁄ 60 of a second (16.7 ...
Graphical scale bar in combination with a scale expressed as a ratio and a conversion help. The scale ratio of a model represents the proportional ratio of a linear dimension of the model to the same feature of the original. Examples include a 3-dimensional scale model of a building or the scale drawings of the elevations or plans of a building ...
The 1:64 scale originated by halving the common 1:32 scale, which was known as "standard size" in some hobbies. This smaller scale became successful because of its relative size in comparison to other toys, the fact that it is a derivative of the 1/16 scale, and because small hands easily hold them. [ 1 ]