Search results
Results from the WOW.Com Content Network
The rather uncommon [citation needed] 40 mm figure scale wargames figures fit approximately into this scale. 1:45: 6.773 mm This is the scale which MOROP has defined for O scale, because it is half the size of the 1:22.5 Scale G-gauge model railways made by German manufacturers. [citation needed] 1:43.5: 7.02 mm: Model railways (0)
35 mm: 1:30: 35 mm (1.378 in) 35 mm was in use in the 1930s and 1940s by several model railway manufacturers in Japan. 35 mm was introduced in the 1930s. Late 1940s 35 mm was replaced by O gauge. No. 2: 1:27: 2 in (50.8 mm) English scale, 7 ⁄ 16 inch to 1 foot. Commercially used about 1900 [citation needed]
A 1:35 scale Learjet 45. 1:35 scale is the most popular scale for model military vehicles, with an extensive lineup of models and aftermarket parts available from a wide variety of manufacturers. It corresponds to 50 mm on figurine scales. The roots of 1:35 as a military modelling scale lie in early motorized plastic tank kits.
To help compare different orders of magnitude, this section lists lengths between 10 −3 m and 10 −2 m (1 mm and 1 cm). 1.0 mm – 1/1,000 of a meter; 1.0 mm – 0.03937 inches or 5/127 (exactly) 1.0 mm – side of a square of area 1 mm²; 1.0 mm – diameter of a pinhead; 1.5 mm – average length of a flea [27]
† Also called a Brale indenter, is made with a conical diamond of 120° ± 0.35° included angle and a tip radius of 0.200 ± 0.010 mm. § The Rockwell number precedes the scale abbreviations (e.g., 60 HRC), except for the "Superficial scales" where they follow the abbreviations, separated by a ‘-’ (e.g., 30N-25).
This scale is also popular in North America to depict 3 ft (914 mm) narrow-gauge prototypes (using dedicated 14.28 mm (0.562 in) gauge track and known as "Sn3"), and elsewhere to depict the 3 ft 6 in (1,067 mm) narrow-gauge railways (using H0 scale 16.5 mm / 0.65 in gauge track and known as "Sn3 1 ⁄ 2") of South Africa, Australia and New Zealand.
Hardness Conversion Table – Brinell, Rockwell,Vickers – Various steels . (archived November 11, 2011) Rockwell to Brinell conversion chart (Brinell, Rockwell A,B,C) Struers hardness conversion table (Vickers, Brinell, Rockwell B,C,D)
The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...