Search results
Results from the WOW.Com Content Network
The temperature of liquid nitrogen can readily be reduced to its freezing point −210 °C (−346 °F; 63 K) by placing it in a vacuum chamber pumped by a vacuum pump. [2] Liquid nitrogen's efficiency as a coolant is limited by the fact that it boils immediately on contact with a warmer object, enveloping the object in an insulating layer of ...
A simplified version of the definition is: The k v factor of a valve indicates "The water flow in m 3 /h, at a pressure drop across the valve of 1 kgf/cm 2 when the valve is completely open. The complete definition also says that the flow medium must have a density of 1000 kg/m 3 and a kinematic viscosity of 10 −6 m 2 /s , e.g. water.
The inlet pressure gauge will indicate this pressure. The gas then passes through the normally open pressure control valve orifice and the downstream pressure rises until the valve actuating diaphragm is deflected sufficiently to close the valve, preventing any more gas from entering the low pressure side until the pressure drops again.
A highly accurate and reliable approach to controlling the nitrogen pressure on a gas-loaded surge relief valve is to use an electronic control system to add and vent nitrogen pressure from the gas-loaded surge relief valve. This technique assures the required set point accuracy and repeatability needed in this critical application.
Pressure in blanketed tanks is maintained by self actuating pressure control valves (PCVs). As liquid is withdrawn from the tank the pressure in the gas space falls. The blanket gas supply valve opens to maintain the pressure. As the tank fills with liquid the pressure rises and a vent gas valve open to vent gas to atmosphere or a vent system. [11]
A hydrostatic test is a way in which pressure vessels such as pipelines, plumbing, gas cylinders, boilers and fuel tanks can be tested for strength and leaks. The test involves filling the vessel or pipe system with a liquid, usually water, which may be dyed to aid in visual leak detection , and pressurization of the vessel to the specified ...
Thermodynamic diagrams are diagrams used to represent the thermodynamic states of a material (typically fluid) and the consequences of manipulating this material. For instance, a temperature– entropy diagram ( T–s diagram ) may be used to demonstrate the behavior of a fluid as it is changed by a compressor.
Instead, a series of different pumps is used, according to the appropriate pressure range for each pump. In the first stage, a roughing pump clears most of the gas from the chamber. This is followed by one or more vacuum pumps that operate at low pressures. Pumps commonly used in this second stage to achieve UHV include: