Search results
Results from the WOW.Com Content Network
When using "hand in" to convert to hands and inches, the rounded hands and inches values are equivalent, and use the same fraction, if any. Special rounding of the inches value only occurs when "hand in" is the output.
Here is a common conversion table with roughness grade numbers: Roughness, N ... microinches (μin.) (μin.) (μm) N12 50 2000 2200 2000 200 N11 25 1000 1100
The alternative Super series, denoted SnR, nR Plus or nR+, has an aspect ratio of 3∶2 (or as close as possible) and thus provides a better fit for standard 135 film (35 mm) at sizes of 8 inches or above. 5R is twice the size of a 2R print, 6R twice the size of a 4R print and S8R twice the size of 6R. 4D/6D is a newer size for most consumer ...
In total, authorities found "a little over 889 kilograms" of cocaine, the Grand Duchy's public prosecutor's office said. The machine had just been delivered when it was intercepted, it added.
The Image Size dialog can be used as an image calculator of sorts. For example, a 1600 × 1200 image with a resolution of 200 ppi will produce a printed image of 8 × 6 inches. The same image with 400 ppi will produce a printed image of 4 × 3 inches. Change the resolution to 800 ppi, and the same image now prints out at 2 × 1.5 inches.
Sizes are often expressed as a fraction of an inch, with a one in the numerator, and a decimal number in the denominator. For example, 1/2.5 converts to 2/5 as a simple fraction, or 0.4 as a decimal number. This "inch" system gives a result approximately 1.5 times the length of the diagonal of the sensor.
The United States adopted the conversion factor 1 metre = 39.37 inches by an act in 1866. [30] In 1893, Mendenhall ordered the physical realization of the inch to be based on the international prototype metres numbers 21 and 27, which had been received from the CGPM, together with the previously adopted conversion factor. [31]
The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...