enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Surge protector - Wikipedia

   en.wikipedia.org/wiki/Surge_protector

   Surge Protection Device (SPD) for installation in a low-voltage distribution board. A surge protector (or spike suppressor, surge suppressor, surge diverter, [1] surge protection device (SPD) or transient voltage surge suppressor (TVSS) is an appliance or device intended to protect electrical devices in alternating current (AC) circuits from voltage spikes with very short duration measured in ...

3. Varistor - Wikipedia

   en.wikipedia.org/wiki/Varistor

   Manufacturer's life-expectancy charts relate current, severity, and number of transients to make failure predictions based on the total energy dissipated over the life of the part. In consumer electronics, particularly surge protectors, the MOV varistor size employed is small enough that eventually failure is expected. [15]

4. Safeguard Your Electronics With These Power Strips and Surge ...

   www.aol.com/avoid-frying-devices-power-strips...

   8-Outlet Surge Protector. The Amazon Basics Surge Protector isn’t super compact, but it is a standout for the 4,500 joules surge protection it provides.

5. These UPS Battery Backups Do a Lot More Than a Regular Surge ...

   www.aol.com/ups-battery-backups-lot-more...

   BE600M1. Most UPS devices take up a lot of floor or desk space. This one, however, measures approximately 4 by 11 by 5.5 inches, which is more compact than most for easier integration into your ...

6. Extend the Life of Your Appliances and Electronics With ... - AOL

   www.aol.com/lifestyle/extend-life-appliances...

   Prevent appliances and electronics from damage—and potentially extend their lifespans—with one of the best whole-house surge protectors on the market today.

7. Transient-voltage-suppression diode - Wikipedia

   en.wikipedia.org/wiki/Transient-voltage...

   A transient-voltage-suppression diode can respond to over-voltages faster than other common over-voltage protection components such as varistors or gas discharge tubes. The actual clamping occurs in roughly one picosecond, but in a practical circuit the inductance of the wires leading to the device imposes a higher limit.