Search results
Results from the WOW.Com Content Network
The basic operation of the gas turbine is a Brayton cycle with air as the working fluid: atmospheric air flows through the compressor that brings it to higher pressure; energy is then added by spraying fuel into the air and igniting it so that the combustion generates a high-temperature flow; this high-temperature pressurized gas enters a ...
In a simple cycle gas-turbine, also known as open-cycle gas-turbine (OCGT) generators, hot gas drives a gas turbine to generate electricity. This type of plant is relatively cheap to build and can start very quickly, but due to its lower efficiency is at most only run for a few hours a day as a peaking power plant. [8]
The LMS100 PA produces approximately 100 MW at an efficiency of around 46% LHV in open cycle operation. It is currently the largest and most efficient aero-derivative gas turbine. It is able to produce full rated power in under 10 minutes. [citation needed] The LMS100 comprises a low-pressure compressor, an intercooler, a supercore and a power ...
The Brayton cycle, also known as the Joule cycle, is a thermodynamic cycle that describes the operation of certain heat engines that have air or some other gas as their working fluid. It is characterized by isentropic compression and expansion, and isobaric heat addition and rejection, though practical engines have adiabatic rather than ...
This low steam turbine entry temperature (compared to a gas turbine) is why the Rankine (steam) cycle is often used as a bottoming [clarification needed] cycle to recover otherwise rejected heat in combined-cycle gas turbine power stations. The idea is that very hot combustion products are first expanded in a gas turbine, and then the exhaust ...
Thermodynamic cycles may be used to model real devices and systems, typically by making a series of assumptions to reduce the problem to a more manageable form. [2] For example, as shown in the figure, devices such a gas turbine or jet engine can be modeled as a Brayton cycle. The actual device is made up of a series of stages, each of which is ...
The first cycle Ericsson developed is now called the "Brayton cycle", commonly applied to gas turbine engines. The second Ericsson cycle is the cycle most commonly referred to as simply the "Ericsson cycle". The (second) Ericsson cycle is also the limit of an ideal gas-turbine Brayton cycle, operating with multistage intercooled compression ...
A simple-cycle combustion turbine (SCCT) is a type of gas turbine typically used in the power generation, aviation , and oil and gas industries (for electricity generation and mechanical drives). The simple-cycle combustion turbine follows the Brayton Cycle and differs from a combined cycle operation in that it has only one power cycle (i.e. no ...