Search results
Results from the WOW.Com Content Network
In a simple cycle gas-turbine, also known as open-cycle gas-turbine (OCGT) generators, hot gas drives a gas turbine to generate electricity. This type of plant is relatively cheap to build and can start very quickly, but due to its lower efficiency is at most only run for a few hours a day as a peaking power plant. [8]
A combined cycle power plant is an assembly of heat engines that work in tandem from the same source of heat, converting it into mechanical energy. On land, when used to make electricity the most common type is called a combined cycle gas turbine (CCGT) plant, which is a kind of gas-fired power plant.
The basic operation of the gas turbine is a Brayton cycle with air as the working fluid: atmospheric air flows through the compressor that brings it to higher pressure; energy is then added by spraying fuel into the air and igniting it so that the combustion generates a high-temperature flow; this high-temperature pressurized gas enters a ...
Didcot OCGT is an Open Cycle Gas Turbine that was originally part of Didcot A. Built in 1968, it uses four open-cycle gas turbines, which are each powered by a pair of Rolls-Royce Avon engines to generate 100MW of electricity. [50] The site was made separate from the Didcot A station as part of the decommissioning process. [51]
The LMS100 PA produces approximately 100 MW at an efficiency of around 46% LHV in open cycle operation. It is currently the largest and most efficient aero-derivative gas turbine. It is able to produce full rated power in under 10 minutes. [citation needed] The LMS100 comprises a low-pressure compressor, an intercooler, a supercore and a power ...
Closed-cycle gas turbine schematic C compressor and T turbine assembly w high-temperature heat exchanger ʍ low-temperature heat exchanger ~ mechanical load, e.g. electric generator. A closed-cycle gas turbine is a turbine that uses a gas (e.g. air, nitrogen, helium, argon, [1] [2] etc.) for the working fluid as part of a closed thermodynamic ...
The cycle is comparable to a gas-generator cycle engine with turbines driven by main combustion chamber exhaust rather than a separate gas generator or preburner. [1] The J-2S rocket engine, a cancelled engine developed by NASA, used the combustion tap-off cycle and was first successfully tested in 1969. [2]
The thermodynamic cycle used by most boiler–turbine generating units. This cycle includes addition of heat in the boiler, extraction of energy through expansion of steam in the turbine, and rejection of heat using the condenser and cooling tower. Brayton cycle: Reaction turbine Design of a Turbine where energy is extracted from the steam ...