Search results
Results from the WOW.Com Content Network
Typical rates in aluminium foil laminates may be as low as 0.001 g/m 2 /day, whereas the rate in fabrics can measure up to several thousand g/m 2 /day. [citation needed] Often, barrier testing is conducted on a sheet of material. Calculations based on that can be useful when designing completed structures, clothing, and packages.
In fire protection engineering, the K-factor formula is used to calculate the volumetric flow rate from a nozzle. Spray nozzles can for example be fire sprinklers or water mist nozzles, hose reel nozzles, water monitors and deluge fire system nozzles.
the rate of rise of the water level in the hole is recorded; the K-value is calculated from the data as: [8] = where: K is the horizontal saturated hydraulic conductivity (m/day) H is the depth of the water level in the hole relative to the water table in the soil (cm): H t = H at time t; H o = H at time t = 0
The draft (draught in British English) flow rate induced by the stack effect can be calculated with the equation presented below. [12] [13] The equation applies only to buildings where air is both inside and outside the buildings. For buildings with one or two floors, h is the height of the building and A is the flow area of the openings.
The saturation with respect to water cannot be measured much below –50 °C, so manufacturers should use one of the following expressions for calculating saturation vapour pressure relative to water at the lowest temperatures – Wexler (1976, 1977), [1] [2] reported by Flatau et al. (1992)., [3] Hyland and Wexler (1983) or Sonntag (1994 ...
At sufficiently high incident light intensity, the ground state of a saturable absorber material is excited into an upper energy state at such a rate that there is insufficient time for it to decay back to the ground state before the ground state becomes depleted, causing the absorption to saturate.
Concrete has a very low coefficient of thermal expansion, and as it matures concrete shrinks. All concrete structures will crack to some extent, due to shrinkage and tension. Concrete which is subjected to long-duration forces is prone to creep. The density of concrete varies, but is around 2,400 kilograms per cubic metre (150 lb/cu ft). [1]
A DoS value of 100% meaning that demand and capacity are equal and no further traffic is able to progress through the junction. The formula to calculate DoS is: Degree of saturation = (demand x cycle time) / (saturation flow x effective green time) Values over 85%-90% typically indicate traffic congestion, with queues of vehicles beginning to form.