Search results
Results from the WOW.Com Content Network
A worn-out wooden threshold. A threshold is the sill of a door. Some cultures attach special symbolism to a threshold. It is called a door saddle in New England. [citation needed] Door thresholds cover the gap between the floor and the door frame, helping to prevent any water leaks, insects or draughts from entering through the opening.
The floors in barns may be packed dirt, stone, or a tightly fitted wood. To keep the grain from falling out the open doorway(s) a board was sometimes placed across the doorway called a threshold, but the term threshold was originally the floor itself [5] or well foot-worn floor boards. [6]
A number of proprietary features for solid wood floors are available. Many solid woods come with grooves cut into the back of the wood that run the length of each plank, often called 'absorption strips,' that are intended to reduce cupping. Solid wood floors are mostly manufactured 0.75 inches (19 mm) thick with a tongue-and-groove for ...
The Janka scale is the force that it takes to embed a steel ball into the hardwood. The more force it takes to do so, the harder the wood. Hardwood floors can either be purchased as pre-finished planks or as planks that need to be sanded and finished in the home following installation.
The end of a piece of wood is butted against another piece of wood. This is reinforced with dowel pins. This joint is quick to make with production line machinery and so is a very common joint in factory-made furniture. Cross dowel joint: A threaded metal dowel is inserted into a drilled slot. A screw is then inserted through an opposing slot ...
This yields veneer that looks like sawn pieces of wood, cut across the growth rings; such veneer is referred to as "crown cut". A half-round lathe in which the log or piece of log can be turned and moved in such a way as to expose the most interesting parts of the grain, creating a more textured feel and appearance; such veneer is commonly ...
Each piece has a slot (the groove or dado) cut all along one edge, and a thin, deep ridge (the tongue) on the opposite edge. The tongue projects a little less than the depth of the groove. Two or more pieces thus fit together closely. The joint is not normally glued, as shrinkage would then pull the tongue off.
Prepainted baseboards can be made from a single piece or finger jointed wood, often softwoods, while hardwoods are either lacquered, or raw for staining and made from a single piece of wood. MDF (medium-density fiberboard) is a common material used for baseboard trim and molding .