enow.com Web Search

  1. Ads

    related to: oil burner nozzle sizes

Search results

  1. Results from the WOW.Com Content Network
  2. Oil burner - Wikipedia

    en.wikipedia.org/wiki/Oil_burner

    An oil burner is a part attached to an oil furnace, water heater, or boiler. [1] It provides the ignition of heating oil/biodiesel fuel used to heat either air or water via a heat exchanger . The fuel is atomized into a fine spray usually by forcing it under pressure through a nozzle which gives the resulting flame a specific flow rate, angle ...

  3. Firebox (steam engine) - Wikipedia

    en.wikipedia.org/wiki/Firebox_(steam_engine)

    The oil burner nozzle is usually mounted in the front of the firebox, protected by a hood of firebrick, and aimed at the firebrick wall below the firebox door. Dampers control air flow to the oil fire. Schematic of a later steam locomotive firebox boiler, with firebox to the left and indicatively showing two superheater elements to the right.

  4. Oil burner (engine) - Wikipedia

    en.wikipedia.org/wiki/Oil_burner_(engine)

    Oil Burning Locomotive: Southern Pacific 2472 at the Niles Canyon Railway An oil burner engine is a steam engine that uses oil as its fuel. The term is usually applied to a locomotive or ship engine that burns oil to heat water, to produce the steam which drives the pistons, or turbines, from which the power is derived.

  5. Fire-tube boiler - Wikipedia

    en.wikipedia.org/wiki/Fire-tube_boiler

    The immersion fired boiler is a single-pass fire-tube boiler that was developed by Sellers Engineering in the 1940s. It has only firetubes, functioning as a furnace and combustion chamber also, with multiple burner nozzles injecting premixed air and natural gas under pressure.

  6. Nozzle - Wikipedia

    en.wikipedia.org/wiki/Nozzle

    Air-aspirating nozzles use an opening in the cone shaped nozzle to inject air into a stream of water based foam (CAFS/AFFF/FFFP) to make the concentrate "foam up". Most commonly found on foam extinguishers and foam handlines. Swirl nozzles inject the liquid in tangentially, and it spirals into the center and then exits through the central hole ...

  7. Tangential firing - Wikipedia

    en.wikipedia.org/wiki/Tangential_firing

    This action is secured through the use of burners located in each of the four corners of the furnace, close to the floor or the water-screen. The burner nozzles are so directed that the streams of coal and air are projected along a line tangent to a small circle, lying in a horizontal plane, at the center of the furnace. Intensive mixing occurs ...

  1. Ads

    related to: oil burner nozzle sizes