Search results
Results from the WOW.Com Content Network
A size chart illustrating the ANSI sizes, superimposed on an "ANSI E" sheet In 1996, the American National Standards Institute adopted ANSI/ASME Y14.1 which defined a regular series of paper sizes based upon the de facto standard 8 + 1 ⁄ 2 in × 11 in (216 mm × 279 mm) Letter size which it assigned "ANSI A", intended for technical drawings ...
The most used of this series is the size A4, which is 210 mm × 297 mm (8.27 in × 11.7 in) and thus almost exactly 1 ⁄ 16 square metre (0.0625 m 2; 96.8752 sq in) in area. For comparison, the letter paper size commonly used in North America ( 8 + 1 ⁄ 2 in × 11 in; 216 mm × 279 mm) is about 6 mm ( 0.24 in ) wider and 18 mm ( 0.71 in ...
The square thread form is a common screw thread profile, used in high load applications such as leadscrews and jackscrews. It gets its name from the square cross-section of the thread. [ 1 ] It is the lowest friction and most efficient thread form, but it is difficult to fabricate.
The size and proportions of a book depend on the size of the original full sheet. If a sheet 480 by 640 mm (19 by 25 in) is used to print a quarto, the resulting untrimmed pages, will be approximately half as large in each dimension: width 240 mm ( 9 + 1 ⁄ 2 in) and height 320 mm ( 12 + 1 ⁄ 2 in).
The internal-drive square socket for screws (as well as the corresponding triangular socket drive) had been conceived several decades before the invention of the Robertson screw and driver. An earlier patent covering both square-socket- and triangle-socket -drive wood screws, U.S. patent 161,390 , was issued to Allan Cummings of New York City ...
A size chart illustrating the ANSI sizes. In 1992, the American National Standards Institute adopted ANSI/ASME Y14.1 Decimal Inch Drawing Sheet Size and Format, [1] which defined a regular series of paper sizes based upon the de facto standard 8 + 1 ⁄ 2 in × 11 in "letter" size to which it assigned the designation "ANSI A".
In Japan, the male sizes are often designated as DTC-20, DTC-27, DTC-40 (discontinued) and DTC-45 corresponding to a respective screw head size of 3.2 mm, 4.6 mm, 6.4 mm and 7.7 mm; with the size of the screw measured across the widest portion of the mating part of the head. The most common sizes in use for consumer electronics are DTC-20 and ...
Sq designates square threads; Tr designates trapezoidal threads; The shank length is not always the same at the thread length, which is the case if the insert has a threadless portion (sub-shank) Tenon designates the thread length; Shoulder designates the barrel diameter in front of the thread portion