Search results
Results from the WOW.Com Content Network
Only the fixed parts of the engine, such as the block and head, are cooled directly by the main coolant system. Moving parts such as the pistons, and to a lesser extent the crankshaft and connecting rods, must rely on the lubrication oil as a coolant, or to a very limited amount of conduction into the block and thence the main coolant. High ...
Yanmar was founded in March 1912 in Osaka, Japan, [2] by Magokichi Yamaoka. [3] [4]When the company began in 1912, it manufactured gasoline-powered engines. [5] In 1920 the company began production of a small kerosene engine. [6]
A Yanmar 2GM20 marine diesel engine, installed in a sailboat. The center pulley is the crankshaft, the lower left one the seawater pump, the upper right one the alternator. The Yanmar 2GM20 is a series of inboard marine diesel engines manufactured by the Japanese company Yanmar Co. Ltd. It is used in a wide range of sailboats and motorboats.
Proper engine coolant and a pressurized coolant system obviate these shortcomings of water. With proper antifreeze, a wide temperature range can be tolerated by the engine coolant, such as −34 °F (−37 °C) to +265 °F (129 °C) for 50% (by volume) propylene glycol diluted with distilled water and a 15 psi pressurized coolant system.
The basic design parameters of the Wankel engine preclude obtaining a compression ratio sufficient for Diesel operation in a practical engine. [104] The Rolls-Royce [ 105 ] and Yanmar compression-ignition [ 106 ] approach was to use a two-stage unit (see figure 16.), with one rotor acting as compressor, while combustion takes place in the other ...
The 4JK1-TCX is an in line direct injection electronic common rail diesel engine with a variable geometry system (VGS) turbocharger and a compression ratio originally at 18.1:1. It was used in the Isuzu D-Max LT 4X4 model, produced in Thailand and Australia, as well as in the related Holden Rodeo and first-generation Chevrolet Colorado.
The coolant pump is driven by the intake side balance shaft, on the flywheel side of the engine. The rectification is to renew the thermostat unit with a modified unit, and if needed in later models, the coolant pump if necessary. However these newer units are still known to leak.
Manual – the driver has to perform each gear change using a manually operated clutch; Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load; Basically there are two types of engine installation: