Search results
Results from the WOW.Com Content Network
Headsets of this type are often referred to by the Dia-Compe (now Cane Creek) registered trademark "Aheadset", [2] [3] and are manufactured under license. Like a traditional headset, it uses two sets of bearings and bearing cups. Unlike a threaded headset, a threadless headset does not have a threaded top headset race or use a threaded steerer ...
The quill stem requires the threaded steerer tube of the fork to extend up through the headset but not protrude beyond it. The quill stem fits down into the inside of the top of steerer tube and is held in place by either a wedge-shaped nut and bolt or a cone-shaped expander nut and bolt. [ 2 ]
Most commonly used on professional microphones, the common 3-pin XLR connector is a standard for transferring balanced audio among professional audio equipment. The 4-pin XLR is the standard connector for intercom headsets, such as systems made by Clear-Com and Telex. Two pins are used for the mono headphone signal and two pins for the ...
A wireless microphone, or cordless microphone, is a microphone without a physical cable connecting it directly to the sound recording or amplifying equipment with which it is associated. Also known as a radio microphone , it has a small, battery-powered radio transmitter in the microphone body, which transmits the audio signal from the ...
Most 2.4 GHz Wireless Headsets come in two units, a wireless headset and a wireless base-station, which connects to your original telephone unit via the handset jack. The wireless headset communicates with the base-station via 2.4 GHz RF, and the voice signals are sent or received via the base unit to the telephone unit.
For example, when you use a mobile phone with a Bluetooth headset, the phone uses SDP to determine which Bluetooth profiles the headset can use (Headset Profile, Hands Free Profile (HFP), Advanced Audio Distribution Profile (A2DP) etc.) and the protocol multiplexer settings needed for the phone to connect to the headset using each of them.
Microphones typically attach to the stand via a detachable microphone holder screwed to the end of the boom. (Some microphones screw directly onto the boom.) Commonly used screw threads (from large to small) are: 5 ⁄ 8 in (16 mm) 27 threads per inch (tpi) Unified Special thread (UNS, U.S. and the rest of the world)
Hands-free sets and headsets often use 3.5 mm or 2.5 mm connectors. TRS connectors are used for mono audio out and an unbalanced microphone (with a shared ground). Four-conductor TRRS phone connectors add an additional audio channel for stereo output.