enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Conical plate centrifuge - Wikipedia

    en.wikipedia.org/wiki/Conical_Plate_Centrifuge

    A set of parallel plates with a tilt angle θ with respect to horizontal plane is installed to reduce the distance of the particle settling. The reason for the tilted angle is to allow the settled solids on the plates to slide down by gravitational force so they do not accumulate and clog the channel formed between adjacent plates. [3]

  3. Parallel (engineering) - Wikipedia

    en.wikipedia.org/wiki/Parallel_(engineering)

    Parallels supporting a vee block and a workpiece. A parallel is a rectangular block of metal, commonly made from tool steel, stainless steel or cast iron, which has 2, [1] 4 or 6 faces ground or lapped to a precise surface finish.

  4. List of moments of inertia - Wikipedia

    en.wikipedia.org/wiki/List_of_moments_of_inertia

    This expression assumes that the rod is an infinitely thin (but rigid) wire. This is a special case of the thin rectangular plate with axis of rotation at the center of the plate, with w = L and h = 0. Thin rod of length L and mass m, perpendicular to the axis of rotation, rotating about one end.

  5. Cone - Wikipedia

    en.wikipedia.org/wiki/Cone

    The axis of a cone is the straight line passing through the apex about which the cone has a circular symmetry. In common usage in elementary geometry, cones are assumed to be right circular, i.e., with a circle base perpendicular to the axis. [1] If the cone is right circular the intersection of a plane with the lateral surface is a conic section.

  6. Viscometer - Wikipedia

    en.wikipedia.org/wiki/Viscometer

    "Cone and plate" viscometers use a narrow-angled cone in close proximity to a flat plate. With this system, the shear rate between the geometries is constant at any given rotational speed. The viscosity can easily be calculated from shear stress (from the torque) and shear rate (from the angular velocity).

  7. Contact mechanics - Wikipedia

    en.wikipedia.org/wiki/Contact_mechanics

    Stresses in a contact area loaded simultaneously with a normal and a tangential force. Stresses were made visible using photoelasticity.. Contact mechanics is the study of the deformation of solids that touch each other at one or more points.

  8. Concrete cone failure - Wikipedia

    en.wikipedia.org/wiki/Concrete_cone_failure

    Concrete cone is one of the failure modes of anchors in concrete, loaded by a tensile force. The failure is governed by crack growth in concrete, which forms a typical cone shape having the anchor's axis as revolution axis .

  9. Dike (geology) - Wikipedia

    en.wikipedia.org/wiki/Dike_(geology)

    The thickness of a dike is much smaller than its other two dimensions, [9] and the opposite walls are roughly parallel, so that a dike is more or less constant in thickness. The thickness of different dikes can range from a few millimeters to hundreds of meters, but is most typically from about a meter to a few tens of meters.