Search results
Results from the WOW.Com Content Network
The cutting of the blocks to size is accomplished with grinding followed by lapping. Usually no plating or other coating is involved. Blocks are kept very lightly oiled, and are stored and used in dry climate-controlled conditions; unplated, uncoated steel gauge blocks can last for decades without rusting.
Air carbon arc cutting, also referred to as metal arc gouging, and previously as air arc cutting, [1] is an arc cutting process where metal is cut and melted by the heat of a carbon arc. Molten metal is then removed by a blast of air. It employs a consumable carbon or graphite electrode to melt the material, which is then blown away by an air jet.
A marking gauge, also known as a scratch gauge, [1] is used in woodworking and metalworking to mark out lines for cutting or other operations. [2] The purpose of the gauge is to scribe a line parallel to a reference edge or surface. It is used in joinery and sheetmetal operations.
The older United States Standard Gauge is based upon 40 lb per square foot per inch thick. Gauge is defined differently for ferrous (iron-based) and non-ferrous metals (e.g. aluminium and brass). The gauge thicknesses shown in column 2 (U.S. standard sheet and plate iron and steel decimal inch (mm)) seem somewhat arbitrary.
A J-groove is formed either with special cutting machinery or by grinding the joint edge into the form of a J. Although a J-groove is more difficult and costly to prepare than a V-groove, a single J-groove on metal between a half an inch and three-quarters of an inch thick provides a stronger weld that requires less filler material.
Small lapping plate made of cast iron. A piece of lead may be used as the lap, charged with emery, and used to cut a piece of hardened steel. The small plate shown in the first picture is a hand lapping plate. That particular plate is made of cast iron. In use, a slurry of emery powder would be spread on the plate and the workpiece simply ...
Granite surface plate calibration should be performed routinely to maintain proper flatness and ensure measurement accuracy over time. The intervals between calibrations depends on the environment where the surface plate is located. When needed, lapping or resurfacing is provided to bring measurements within grade guidelines.
The gauge is placed against the edge to be checked and any light leakage between the blade and edge indicates a mismatch that requires correction. Ring gauge: a cylindrical ring of steel whose inside diameter is finished to gauge tolerance and is used for checking the external diameter of a cylindrical object. Strain gauge