Search results
Results from the WOW.Com Content Network
Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.
Exterior wall studs are the vertical members to which the wall sheathing and cladding are attached. [14] They are supported on a bottom plate or foundation sill and in turn support the top plate. Studs usually consist of 1 + 1 ⁄ 2 -by- 3 + 1 ⁄ 2 -inch (38 mm × 89 mm) or 1 + 1 ⁄ 2 -by- 5 + 1 ⁄ 2 -inch (38 mm × 140 mm) lumber and are ...
Lower wall plates, base plate, floor plate, or bottom plate [4] — a second lower wall plate to which the wall studs are through nailed and which is the bottom of the wall section when assembled as a rectangular assembly. On an upper story, the lower wall plate is nailed to the platform of the supporting floor. The supporting platform is being ...
In light-frame construction, a trimmer is a timber or metal beam (joist) used to create an opening around a stairwell, skylight, chimney, and the like. Trimmers are installed parallel to the primary floor or ceiling joists and support headers, which run perpendicular to the primary joists.
Blocking placed as attachment points for cabinets, while doubling as bracing against compression of the studs. Blocking ( dwang , nog, noggin, and nogging) is the use of short pieces of dimensional lumber in wood framed construction to brace longer members or to provide grounds for fixings.
The Home Depot showcased their Halloween 2024 decorations, and a 7 foot dog is now included. Read about where and how to buy the Halloween item!
The wall finish is anchored to the two flange sides of the stud, which varies from 1 + 1 ⁄ 4 to 3 inches (32 to 76 mm) thick, and the width of web ranges from 1 + 5 ⁄ 8 to 14 inches (41 to 356 mm). Rectangular sections are removed from the web to provide access for electrical wiring.
DIN 18101/1985 defines interior single molded doors to have a common panel height of 1985 mm (normativ height 2010 mm) at panel widths of 610 mm, 735 mm, 860 mm, 985 mm, 1110 mm, plus a larger door panel size of 1110 mm x 2110 mm. [25] The newer DIN 18101/2014 drops the definition of just five standard door sizes in favor of a basic raster ...