Search results
Results from the WOW.Com Content Network
AHCI gives software developers and hardware designers a standard method for detecting, configuring, and programming SATA/AHCI adapters. AHCI is separate from the SATA 3 Gbit/s standard, although it exposes SATA's advanced capabilities (such as hot swapping and native command queuing) such that host systems can
The SATA functionality remains, but is now branded as Intel VROC (SATA RAID). Intel RSTe is no longer a referenced product by Intel. The name may still appear in some legacy products, but all new references will solely use the Intel VROC nomenclature. [6] [7]). Intel RST is provided by a combination of firmware, chipset and CPU capabilities ...
A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...
The SAS is a new generation serial communication protocol for devices designed to allow for much higher speed data transfers and is compatible with SATA. SAS uses a mechanically identical data and power connector to standard 3.5-inch SATA1/SATA2 HDDs, and many server-oriented SAS RAID controllers are also capable of addressing SATA hard drives.
Another example of software that shows the health of the drive and its smart attributes. This Intel 120GB SSD also appears to be in perfect condition. [2] Self-Monitoring, Analysis, and Reporting Technology (S.M.A.R.T. or SMART) is a monitoring system included in computer hard disk drives (HDDs) and solid-state drives (SSDs). [3]
The Serial ATA interface was designed primarily for interfacing with hard disk drives (HDDs), doubling its native speed with each major revision: maximum SATA transfer speeds went from 1.5 Gbit/s in SATA 1.0 (standardized in 2003), through 3 Gbit/s in SATA 2.0 (standardized in 2004), to 6 Gbit/s as provided by SATA 3.0 (standardized in 2009). [9]
A Serial ATA port multiplier is a unilateral splitting device. While it allows one equipped port to connect up to 15 disks, the bandwidth available is limited to the bandwidth of the link to the controller, as of 2012 1.5, 3, or 6 Gbit/s. [3]
When enabled via the AHCI controller, this allows the SATA host bus adapter to enter a low-power state during periods of inactivity, thus saving energy. The drawback to this is increased periodic latency as the drive must be re-activated and brought back on-line before it can be used, and this will often appear as a delay to the end-user.