Search results
Results from the WOW.Com Content Network
A manual transmission (MT), also known as manual gearbox, standard transmission (in Canada, the United Kingdom and the United States), or stick shift (in the United States), is a multi-speed motor vehicle transmission system where gear changes require the driver to manually select the gears by operating a gear stick and clutch (which is usually ...
The clutch brake not only slows or stops the idle gear axis but can also prevent shifting into gear until the clutch pedal is released a few centimetres (or inches) off the floor. In order to shift into gear, the clutch must be halfway off the floor, otherwise, the clutch brake will prevent the transmission from being shifted into or out of gear.
Clutch control is the controlling of the speed of a manual transmission vehicle by partially engaging the clutch plate, using the clutch pedal instead of (or in conjunction with) the accelerator pedal. The purpose of a clutch is in part to allow such control; in particular, a clutch provides transfer of torque between shafts spinning at ...
Preselector gearboxes were most common prior to the widespread adoption of the automatic transmission, so they were considered in comparison to the "crash gearbox" type of manual transmission. Preselector gearboxes were often marketed as "self-changing" gearboxes, [ 1 ] however this is an inaccurate description as the driver is required to ...
Automated manual transmissions can be semi-automatic or fully-automatic in operation. Several different systems to automate the clutch and/or shifting have been used over the years, but they will generally use one of the following methods of actuation for the clutch and/or shifting: hydraulic or electro-hydraulic actuation, [12] electro-mechanical, [13] pneumatic, [6] [14] [15] electromagnetic ...
Manual – the driver has to perform each gear change using a manually operated clutch; Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load; Basically there are two types of engine installation:
One-way bearing combining sprags and bearing rollers in one race Sprags jam when driven and slide when in reverse. A sprag clutch is a one-way freewheel clutch.It resembles a roller bearing but, instead of cylindrical rollers, non-revolving asymmetric figure-eight shaped sprags, or other elements allowing single direction rotation, are used.
Gear shift lever on a motorcycle (above the toe of the rider's boot) A sequential manual transmission is unsynchronized, and allows the driver to select either the next gear (e.g. shifting from first gear to second gear) or the previous gear (e.g., shifting from third gear to second gear), operated either via electronic paddle-shifters mounted behind the steering wheel or with a sequential ...