Ads
related to: end fed half square antenna reviews pros and cons laptopebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
An antenna such as the one described above is usable for both local and medium-long-distance communication across a frequency range of about 1:6 . For example, an antenna for the lower portion of shortwave (say, 3–18 MHz) will be roughly 33 m (110 feet) long, with conductors spaced 1 m (3.3 feet). For the higher portion of shortwave (5–30 ...
the upper half of a vertical full-wavelength loop antenna mounted on the ground (not to be confused with the visually similar but electrically different half-square antenna described below, under array antennas, [t] nor to be confused with the halo antenna, described next). The full loop is cut at two opposite points along its perimeter, and ...
The angle of the slope is usually between 45°–60° and the lower end of the wire is at least 1 ⁄ 6 wavelength above the electrical ground. [3] A sloper is typically fed with a coaxial cable in the center, at the top of the center support mast. At least 1 ⁄ 4 of the wavelength of feedline must be at 90° angle to the antenna. [3]
The J-pole antenna is an end-fed omnidirectional half-wave antenna that is matched to the feedline by a shorted quarter-wave parallel transmission line stub. [5] [1] [6] For a transmitting antenna to operate efficiently, absorbing all the power provided by its feedline, the antenna must be impedance matched to the line; it must have a resistance equal to the feedline's characteristic impedance.
The HB9XBG antenna is a vertical dipole antenna for short wave radio amateurs. It was developed by the Swiss radio amateur Walter Kägi, whose call sign HB9XBG is also the designation of the antenna. [1] During the test phase in 2020, HB9XBG built two vertical dipoles – one for the 20-metre amateur radio band and another for the 40-metre band.
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
A more recent phenomenon for indoor antennas are flat antennas, which are lightweight, thin, and usually square-shaped with the claim of having more omnidirectional reception. They are also marketed as being more in line with modern minimalistic home designs. [14] Flat antennas may have a stand or could be hung on a wall or a window. [15]
Moxon antenna for the 20-meter band.The antenna is the faint rectangle of wires held in tension by the bent X-shaped support frame. Moxon antenna for the 2-meter band. The Moxon antenna or Moxon rectangle is a simple and mechanically rugged two-element parasitic array, single-frequency antenna. [1]
Ads
related to: end fed half square antenna reviews pros and cons laptopebay.com has been visited by 1M+ users in the past month